Справочник Пользователя для Insignia NS-AV511

Insignia NS-AV511 Surround Sound Receiver

www.insigniaproducts.com

Reception is noisy, 
FM stereo reception 
is noisy, or the FM 
STEREO indicator 
does not light

• Relocate your antenna.
• Move the receiver away from your TV or computer.
• Listen to the station in mono.
• When listening to an AM station, operating the remote 

control may cause noise.

• Passing cars and airplanes can cause interference.
• Concrete walls weaken radio signals.
• If nothing improves the reception, install an outdoor 

antenna.

Cannot connect to a 
Rocketboost 
network

• If the joining process is failing, make sure that only one of 

your Rocketboost wireless devices has the Hub switch 
enabled.

• Make sure that you have installed the RF-RBCARD (sold 

separately).

• Make sure that the link is established by Rocketboost setup 

menu. For more information, see “Establishing 
communications with other Rocketboost products“ on page 
12.

• The maximum number of Rocketboost devices in a 

Rocketboost Network is nine. If you already have nine 
devices and attempt to join another one, then joining will 
fail for the new device. Remove (power down) one of your 
devices and try again.

The remote control 
does not work

• Before operating this unit, be sure to press RECEIVER.
• Make sure that the batteries are installed with the correct 

polarity.

• Install new batteries. Don’t mix different types of batteries, 

or old and new batteries.

• Make sure that the remote control is not too far away from 

the receiver, and that there’s no obstruction between the 
remote control and the receiver’s remote control sensor.

• Make sure that the receiver is not subjected to direct 

sunshine or inverter-type fluorescent lights. Relocate if 
necessary.

• If the receiver is installed in a rack or cabinet with 

colored-glass doors, the remote control may not work 
reliably when the doors are closed.

• Make sure you’ve selected the correct remote control mode.
• Make sure you’ve entered the correct remote control code.
• Make sure to set the same ID on both the receiver and 

remote control.

Cannot control 
other components

• Make sure that you have selected the correct remote control 

mode.

• If you cannot operate it, you need to enter the appropriate 

remote control code.

Cannot record

• On your recorder, make sure the correct input is selected.
• To prevent signal loops and damage to the receiver, input 

signals are not fed through to outputs with the same name 
(for example, VCR/DVR IN to VCR/ DVR OUT).

The sound changes 
when I connect my 
headphones

• When a pair of headphones is connected, the listening 

mode is set to Stereo, unless it’s already set to Stereo, Mono, 
or Direct.

How do I change 
the language of a 
multiplex source

• Use  the  Multiplex setting on the Audio Adjust menu to 

select Main or Sub.

The following 
settings can be 
made for the 
composite video 
inputs

You must use the buttons on the unit to make these settings.
1. While holding down the input selector button for the input 
source that you want to set, press SETUP.

2. Use 

/

 to change the setting.

3. Press the input selector button for the input source that you 
want to set when you have finished.
Video Attenuation

This setting can be made for the BD/DVD, VCR/DVR, CBL/SAT, 
GAME, or AUX input.
If you have a game console connected to the composite video 
input, and the picture is not very clear, you can attenuate the 
gain.

• Video ATT–0: (default).
• Video ATT–2: Gain is reduced by 2 dB.

Design and specifications are subject to change 
without notice.

90 watts minimum continuous power per channel, 8 ohm 
loads, 1 channel driven at 1 kHz with a maximum total 
harmonic distortion of 1%.

0.08% (1 kHz, 1 W)

200 mV/47 kohms (LINE)

200 mV/2.2 kohms (REC OUT)

20 Hz - 50 kHz/+1 dB - 3 dB (DSP bypass)

±10 dB, 50 Hz (BASS)
±10 dB, 20 kHz (TREBLE)

90 dB (LINE, IHF-A)

6 ohms - 16 ohms

1 Vp-p/75 ohms (Component)
0.7 Vp-p/75 ohms (Component PB/CB, PR/CR)
1 Vp-p/75 ohms (Composite)

5 Hz - 100 MHz/±0 dB, - 3 dB

NS-AV511_11-0201_MAN_.book  Page 31  Wednesday, April 13, 2011  9:31 AM