Справочник Пользователя для Honeywell CMR707A1049
SETTING-UP THE CMR707
‘
Getting Started’
This section shows you how to setup and run the thermostat in 3 simple steps:
STEP 1: Installing the Batteries
Note:
if the ‘Low Battery’ Indicator
is showing or the thermostat screen is blank (no symbols
or digits are displayed) replace the batteries as follows, otherwise, please go directly to Step 2:
Setting the Date and Time
.
To install the Batteries:
a.
a.
Lift up the front cover of the thermostat to reveal the battery cover and product controls.
b.
Remove the battery cover by pressing down and sliding out.
c.
Insert the 2 x AA LR6 Alkaline Batteries supplied with the thermostat, ensuring the correct
orientation (see ‘Controls Layout’ on page 2).
d.
After a short pause the thermostat will display information on the screen and is now ready for use.
e
. Replace the battery cover by sliding it firmly back into the front of the thermostat.
STEP 2: Setting the Day and Time
To set the Day and Time:
a.
a.
Press the DAY button once and the ‘day indicator’ will begin to flash.
b.
Press the DAY button until the correct day is reached (Day 1 = Monday). Press the green
button to confirm.
d.
Press either of the or buttons once to enter time setting mode. The LCD screen flashes
the time digits (when the unit is powered for the first time the display shows 12:00).
e.
Use the or buttons to set the correct time then press the green
button to confirm.
Each press of the buttons will change the time by one minute and holding them down will
change the time slowly at first and get progressively quicker.
Note: If this mode is entered accidentally then press the AUTO, MAN or OFF buttons to exit.
STEP 3: Running the Built-in Heating Program
The thermostat is now ready for operation. Press the AUTO button and the built-in heating program will start
running. Note: The built-in heating program has been designed to provide normal comfort requirements,
but if you want to customise the settings please see the next section ‘Programming the CMR707’.
PROGRAMMING THE CMR707
‘Efficient Daily Use’
The Built-in Heating Program
The built-in heating program has 4 temperature level changes per day that can be set between
3.00am and 2.50am the following day - allowing you to maintain the evening temperature after
midnight. Each temperature level can be set between 5°C and 35°C, and adjusted in 0.5°C
increments. The factory default program for heating is as follows.
Period
1
2
3
4
Time
6:30
8:00
18:00
22:30
Temperature
21°C
18°C
21°C
16°C
Period
1
2
3
4
Time
8:00
10:00
18:00
23:00
Temperature
21°C
21°C
21°C
16°C
PLEASE RESPECT YOUR ENVIRONMENT! Take care to dispose of used batteries carefully.
Monday to Friday
(Day 1 to 5)
Saturday & Sunday
(Day 6 & 7)