Инструкция для Sony CFD-S05

CFD-S05.US.4-174-567-12(1)

to a wall outlet

to AC IN





To reduce the risk of fire, do not cover the ventilation 

of the apparatus with newspapers, tablecloths, 

curtains, etc. And do not place lighted candles on the 

apparatus.
To reduce the risk of fire or electric shock, do not expose 

this apparatus to dripping or splashing, and do not 

place objects filled with liquids, such as vases, on the 

apparatus.
As the main plug is used to disconnect the unit from 

the mains, connect the unit to an easily accessible 

AC outlet. Should you notice an abnormality in the 

unit, disconnect the main plug from the AC outlet 

immediately.
The unit is not disconnected from the AC power source 

(mains) as long as it is connected to the wall outlet, 

even if the unit itself has been turned off.
Do not install the appliance in a confined space, such 

as a bookcase or built-in cabinet.

Do not expose the batteries (battery pack or batteries 

installed) to excessive heat such as sunshine, fire or the 

like for a long time.
The nameplate and important information concerning 

safety are located on the bottom exterior.

A DualDisc is a two sided disc product which mates 

DVD recorded material on one side with digital audio 

material on the other side. However, since the audio 

material side does not conform to the Compact 

Disc (CD) standard, playback on this product is not 

guaranteed.

This product is designed to playback discs that 

conform to the Compact Disc (CD) standard. Recently, 

various music discs encoded with copyright protection 

technologies are marketed by some record companies. 

Please be aware that among those discs, there are 

some that do not conform to the CD standard and may 

not be playable by this product.

4-174-567-12(1)

CD Radio Cassette-Corder

The use of optical instruments with this product will 

increase eye hazard.

This symbol is intended to alert the user to the 

presence of uninsulated “dangerous voltage” within 

the product’s enclosure that may be of sufficient 

magnitude to constitute a risk of electric shock to 

persons.

This symbol is intended to alert the user to the 

presence of important operating and maintenance 

(servicing) instructions in the literature accompanying 

the appliance.

This equipment has been tested and found to 

comply with the limits for a Class B digital device, 

pursuant to Part 15 of the FCC Rules. These limits are 

designed to provide reasonable protection against 

harmful interference in a residential installation. This 

equipment generates, uses, and can radiate radio 

frequency energy and, if not installed and used in 

accordance with the instructions, may cause harmful 

interference to radio communications. However, there 

is no guarantee that interference will not occur in a 

particular installation. If this equipment does cause 

harmful interference to radio or television reception, 

which can be determined by turning the equipment 

off and on, the user is encouraged to try to correct the 

interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and 

receiver.

– Connect the equipment into an outlet on a 

circuit different from that to which the receiver is 

connected.

– Consult the dealer or an experienced radio/TV 

technician for help.

You are cautioned that any changes or modifications 

not expressly approved in this manual could void your 

authority to operate this equipment.

Please register this product on line at

Proper registration will enable us to send you 

periodic mailings about new product, services 

and other important announcements. Registering 

your product will also allow us to contact you 

in the unlikely event that the product needs 

adjustment or modification. Thank you.

1)  Read these instructions. 
2)  Keep these instructions. 
3)  Heed all warnings. 
4)  Follow all instructions. 
5)  Do not use this apparatus near water. 
6)  Clean only with dry cloth. 
7)  Do not block any ventilation openings.  

Install in accordance with the manufacturer’s 

instructions. 

8)  Do not install near any heat sources such as radiators, 

heat registers, stoves, or other apparatus (including 

amplifiers) that produce heat. 

9)  Do not defeat the safety purpose of the polarized or 

grounding-type plug. A polarized plug has two blades 

with one wider than the other. A grounding type plug 

has two blades and a third grounding prong. The wide 

blade or the third prong are provided for your safety. If 

the provided plug does not fit into your outlet, consult 

an electrician for replacement of the obsolete outlet. 

10)  Protect the power cord from being walked on or 

pinched particularly at plugs, convenience receptacles, 

and the point where they exit from the apparatus. 

11)  Only use attachments/accessories specified by the 

manufacturer. 

12)  Use only with the cart, stand, tripod, bracket, or table 

specified by the manufacturer, or sold with the 

apparatus. When a cart is used, use caution when 

moving the cart/apparatus combination to avoid injury 

from tip-over.

13)  Unplug this apparatus during lightning storms or when 

unused for long periods of time. 

14)  Refer all servicing to qualified service personnel. 

Servicing is required when the apparatus has been 

damaged in any way, such as power-supply cord or 

plug is damaged, liquid has been spilled or objects have 

fallen into the apparatus, the apparatus has been 

exposed to rain or moisture, does not operate normally, 

or has been dropped.

POWER OUTPUT AND TOTAL HARMONIC DISTORTION

With 4-ohm loads, both channels driven from 150 Hz - 10,000 Hz; rated 1 W 

per channel-minimum RMS power, with no more than 10 % total harmonic 

distortion in AC operation.

System

Compact disc digital audio system

Laser diode properties

Emission duration: Continuous

Laser output: Less than 44.6 µW

(This output is the value measured at a distance of  

about 200 mm from the objective lens surface on the  

optical pick-up block with 7 mm aperture.)

Number of channels

2

Frequency response

20 Hz - 20,000 Hz +1/–2 dB

Wow and flutter 

Below measurable limit

Frequency range

FM:  87.5 MHz - 108 MHz

AM:  530 kHz - 1,710 kHz

Antennas

FM:  Telescopic antenna

AM:  Built-in ferrite bar antenna

Recording system

4-track 2 channel stereo

Fast winding time

Approx. 150 s (sec.) with Sony cassette C-60

Frequency response

TYPE I (normal): 80 Hz - 10,000 Hz

Speaker

Full range: 8 cm (3 

1

/

4

 inches) dia., 4 



, cone type (2)

Outputs

Headphones jack (stereo minijack):

For 16 



 - 32 



 impedance headphones

Input

AUDIO IN jack (stereo minijack)

Power output

1.7 W + 1.7 W (at 4 



, 10% harmonic distortion)

Power requirements

For CD radio cassette-corder: 

120 V AC, 60 Hz

9 V DC, 6 R14 (size C) batteries

Power consumption 

AC 13 W

Battery life

For CD radio cassette-corder:

Sony R14P: approx. 4.5 h 
Sony alkaline LR14: approx. 19 h

Sony R14P: approx. 2.5 h
Sony alkaline LR14: approx. 13 h

Sony R14P: approx. 1 h
Sony alkaline LR14: approx. 8 h

Dimensions

Approx. 365 mm × 134 mm × 230 mm (w/h/d)

(14 

3

/

8

 inches × 5 

3

/

8

 inches × 9 

1

/

8

 inches) (incl. projecting parts)

Mass

Approx. 2.7 kg (5 lb. 15 oz) (incl. batteries)

Supplied accessory

AC power cord (1)

Design and specifications are subject to change without notice.

Sony MDR headphones series

CFD-S05

Operating Instructions

©2010 Sony Corporation     

Printed in China

The model number is located at the bottom and the serial number is located in 

the battery compartment. Record these numbers in the space provided below. 

Refer to them whenever you call upon your Sony dealer regarding this product.
Model No. CFD-S05     

Serial No. ______________

Connect the AC power cord  or insert six R14 (size C) batteries (not supplied) into the battery compartment .



  Replace the batteries when the OPR/BATT indicator 



 dims or when the unit stops operating. 

Replace all the batteries with new ones. Before you replace the batteries, be sure to take out the CD from the unit.



  To use the unit on batteries, disconnect the AC power cord from the unit.



  Audio CD



  CD-R/CD-RW (CD-DA*)

* CD-DA is the abbreviation for Compact Disc Digital Audio. It is a 

recording standard used for Audio CDs.



  CD-R/CD-RW other than those recorded in music CD format



  CD-R/CD-RW of poor recording quality, CD-R/CD-RW that 

has scratches or are dirty, or CD-R/CD-RW recorded with an 

incompatible recording device



  CD-R/CD-RW which is finalized incorrectly



  Before playing, clean the CD with a 

cleaning cloth. Wipe the CD from the 

center out. If there is a scratch, dirt or 

fingerprints on the CD, it may cause 

tracking error. 



  Do not use solvents such as benzine, thinner, commercially 

available cleaners or anti-static spray intended for vinyl LPs.



  Do not expose the CD to direct sunlight or heat sources such as 

hot air ducts, nor leave it in a car parked in direct sunlight as there 

can be a considerable rise in temperature inside the car.



  Do not stick paper or sticker on the CD, nor scratch the surface of 

the CD.



  After playing, store the CD in its case.



  As the laser beam used in the CD player section is harmful to the 

eyes, do not attempt to disassemble the casing. Refer servicing to 

qualified personnel only.



  Should any solid object or liquid fall into the unit, unplug the 

unit, and have it checked by qualified personnel before operating 

it any further.



  Discs with non-standard shapes (e.g., heart, square, star) cannot 

be played on this unit. Attempting to do so may damage the unit. 

Do not use such discs.



  For AC operation, use the supplied AC power cord; do not use any 

other type. 



  Unplug the unit from the wall outlet when it is not be used for an 

extended period of time.



  When the batteries are not to be used, remove them to avoid 

damage that can be caused by battery leakage or corrosion.



  Do not leave the unit in a location near heat sources, in a place 

subject to direct sunlight, excessive dust or mechanical shock or 

in a car subject to the direct rays of the sun.



  Do not place the unit on an inclined or unstable place.



  Do not place anything within 10 mm of the side of the cabinet. 

The ventilation holes must be unobstructed for the unit to 

operate properly and prolong the life of its components.



  Since a strong magnet is used for the speakers, keep personal 

credit cards using magnetic coding or spring-wound watches 

away from the unit to prevent possible damage from the magnet.



  If the unit is brought directly from a cold to a warm location, or is 

placed in a very damp room, moisture may condense on the lens 

inside the CD player section. Should this occur, the unit will not 

operate properly. In this case, remove the CD and wait about an 

hour for the moisture to evaporate.



  If the unit has not been used for a long time, set it in the playback 

mode to warm it up for a few minutes before inserting a cassette.



  Break off the cassette tab from 

side A or B to prevent accidental 

recording. If you want to reuse 

the tape for recording, cover the 

broken tab with adhesive tape.

Tab for side B

Side A

Tab for side A



  The use of a cassette with more than 90 minutes of play time 

is not recommended except for long, continuous recording or 

playback.



  Clean the cabinet, panel and controls with a soft cloth slightly 

moistened with a mild detergent solution. Do not use any type 

of abrasive pad, scouring powder, or solvent, such as alcohol or 

benzine.

If you have any questions or problems concerning your unit, please 

consult your nearest Sony dealer.