Справочник Пользователя для Integra DTR-10.5
142
Other Settings for the Remote Controller
—Continued
This section explains how to change the remote control-
ler’s ID. You may need to change this if the DTR-10.5’s
remote controller interferes with other Integra/Onkyo
components located in the same room.
ler’s ID. You may need to change this if the DTR-10.5’s
remote controller interferes with other Integra/Onkyo
components located in the same room.
Note:
If you change the remote controller’s ID, be sure to
select the same ID on the DTR-10.5. For details on set-
ting up the DTR-10.5’s remote control ID, refer to the
“Remote Control Setup Sub-menu” section on page 87.
The default ID for both the DTR-10.5 and remote con-
troller is 1.
select the same ID on the DTR-10.5. For details on set-
ting up the DTR-10.5’s remote control ID, refer to the
“Remote Control Setup Sub-menu” section on page 87.
The default ID for both the DTR-10.5 and remote con-
troller is 1.
Changing the Remote Controller’s
Control ID
Control ID
1
Hold down the remote controller’s [Cus-
tom] button for more than three seconds.
tom] button for more than three seconds.
The remote controller enters Custom mode.
2
Roll the scroll wheel to select “SETUP”
menu, and then press the scroll wheel.
menu, and then press the scroll wheel.
3
Roll the scroll wheel to select ID menu,
and then press the scroll wheel.
and then press the scroll wheel.
4
Roll the scroll wheel to select an
ID—1 (default), 2, or 3—and then
press the scroll wheel.
ID—1 (default), 2, or 3—and then
press the scroll wheel.
Select the same ID as that set on the
DTR-10.5.
DTR-10.5.