Справочник Пользователя для Dolmar PS-351

0

Move at least  meters / 0 feet away from the place where the 

chain saw was fuelled.

Make sure you have a secure footing, and place the saw on 

the ground in such a way that the guide bar and chain are not 

near anything.

Actuate the chain brake (block it).

Hold the front handle firmly with one hand and press the saw 

against the ground.

Hold the down rear handguard with your right foot as shown.
Note:  The  Featherlight-Start  System  lets  you  start  the  saw 

without effort. Go through the starting procedure smoothly and 

evenly. 

Prime the fuel pump (5) by pressing it several times until you 

can see fuel in the pump.
Move the combination switch (1) up (choke position). This also 

actuates the half-throttle lock.
Pull the starter handle (2) smoothly and evenly.
CAUTION: Do not pull the starter cable more than about 20” 

(50cm) out, and let it back in slowly by hand.
Repeat the starting procedure twice.
Move the combination switch (1) to the central “ON” position.  

Pull the starter handle smoothly and evenly again. As soon as 

the engine is running, grasp the rear handle (the safety lock 

button (3) is actuated by the palm of the hand) and press the 

throttle trigger (4).
CAUTION: The engine must be put in idle immediately after 

starting. If this is not done, the clutch can be damaged.
Now disengage the chain brake.

As described above for cold starting, but before starting push 

the combination switch (1) up (Choke position) and
then right away back to the middle “ON” position. This is only 

to engage the half-throttle lock. If the engine doesn’t start after 

2 or  pulls, repeat the entire starting procedure as described 

for cold starting.
NOTE: If the engine was switched off only for a short time, the 

saw can be started without using the combination switch.
Important: If the fuel tank has been completely emptied and the 

engine has stopped due to lack of fuel prime the fuel pump (5) by 

pressing it several times until you can see fuel in the pump.

Depress the combination switch             (1).
NOTE: After being pressed down, the combination switch will 

revert to the ON position again. The engine is switched off, but can 

be turned on again without moving the combination switch.
IMPORTANT: To cut off the ignition current, push the combina-

tion switch all the way down past the resistance point to the 

safety position (   ).

(ignition current cut off, 

necessary for all mainte-

nance, repair, and instal-

lation work)