Справочник Пользователя для Jacuzzi J - 465

Page 63

6.  Once back to the “Program B” Main  

Menu, press the Down button on the 

Quad Keypad to select “Start Time” 

(Figure M). Press the Left or Right 

button on the Quad Keypad to select 

the time you wish the spa to run. 

Press the Down button on the Quad 

keypad to access the “Duration” 

setting.

note: If you are using a standard 12-hour period, you will see the hour 

displayed as “1PM”. For the 24-hour period it will read “1300”.

7.  Now you will need to adjust the 

“Duration” (Figure N) of the cycle. 

The duration range is from 0 (OFF) 

to 6 hours. Press the Left or Right 

button on the Quad Keypad to make 

your adjustment(s) in increments of 1 

hour. 

note: The default “Duration” is OFF.

8.  Press the Splash button on the Quad Keypad to save your changes 

and return to the Heating Menu.

9.  Press button D to exit the Heating 

Menu and return to the Settings 2 

Main Menu. If you have 

programmed both heating cycles 

and the settings have been 

accepted, you will see the two 

program icons next to word Heating 

on the display (Figure O). If only one 

cycle was programmed, there will only be one icon. If no 

cycles were programmed there would be a thermometer with wavy 

arrows as the icon.

The clean-up cycle is once per day in both Auto-Heating and 

Programmable modes at 12:00 (noon) for two minutes. This is not user 

programmable. Each jets pump activates for one minute to circulate any 

water in the plumbing unless a pump has just finished a 20 minute time 

out, it will not automatically activate for the clean-up cycle. Be aware, the 

factory programmed clean-up cycle cannot be canceled or altered!

PROGRAM   B

Start Time

Day Settings

Duration

Select

B

Start Time

Press         to save

1AM

Figure M

PROGRAM B

Start Time

Day Settings

Duration

Select

B

Press         to enter

Duration

OFF

Figure N

Primary
Secondary
Heating

Press         to 

reset to default

SETTINGS 2

OFF

A

B

Figure O