Справочник Пользователя для Multiquip MC-44S

NEVER ! tow the mixer with the safety chain

removed. The safety chain is intended  to

prevent 

 complete separation of the mixer from

the towing vehicle in the event of a tow bar

failure.

Reference Figure 5 for the installation of the 

Safety Chain.

1. Insert the tow bar through the round opening at the

bottom of the mixer stand.

Align the hole on the tow bar with the hole on the mixer
frame, and insert 1/2-inch bolt through tow bar and frame.
Secure tow bar to frame with 1/2-inch nylock nut. Tighten
to 40 ft.-lbs.

2. Route the safety chain through the holes just above the

tow bar, located on each side of the mixer stand.

Loop the chain together and place under the tow bar.
Secure the loop with the connector link.

3. Extend the safety chain along the length of the tow bar,

looping it through the tow bar's connector link. Remove
any excess chain slack.

4. Connect the free end of (clevis safety hook) the safety

chain to the towing vehicle. 

that the length of the chain be properly adjusted, to
prevent the 

draw bar and the front of the mixer stand

from dropping to the the ground (contact) in the event
the draw bar becomes disconnected from the towing
vehicle.