Справочник Пользователя для Mitsubishi Electronics 60/60S

6.  Operation Panel Switch Functions 

6.14  Handle Interruption 

 

 

 

II-23 

 
 

(1)  The movement speed of the axis for which handle interruption is executed, may exceed the rapid 

traverse feed rate during rapid traverse feed command (G00) processing in automatic start. To prevent 
this, clamp the axis. (The movement speed equals Automatic-start movement speed + Speed resulting 
from manual handle interruption.) 

 

(2)  The movement speed of the axis for which handle interruption is executed, may exceed the cutting feed 

speed during cutting feed command (G01, G02, G03) processing in automatic start. To prevent this, 
clamp the axis. (The movement speed equals Automatic start movement speed + Speed resulting from 
manual handle interruption.) 

 

(3)  If, during automatic start, manual handle interruption is executed, in the same direction, for the axis that 

is moving at an external decelerating speed, the axis movement speed may exceed the external 
decelerating speed. To prevent this, clamp the axis. (The movement speed equals Automatic start 
movement speed + Speed resulting from manual handle interruption.) 

 

(4)  If an attempt is made to execute interruption at a speed exceeding the clamp speed, the reading on the 

handle scale does not match the distance of interruption. 

 

(5)  The handle scale factor depends on the selected input of the manual handle/step scale factor.