Справочник Пользователя для Addonics Technologies RTM2233EU3

www.addonics.com

Technical Support (M-F 8:30am - 6:00pm PST)   

Phone: 408-453-6212 

Email: www.addonics.com/support/query/

Note: When configured as a set of individual drives, the Port Multiplier will only work with a Port 

Multiplier aware host. Identify your host controller and check with its hardware manufacturer if 

you are unsure. Addonics offers several Port Multiplier capable host adapters.

Loosen the 3 screws at the back of 

the towerusing a Philips screwdriver 

by turning counter-clockwise. Separate 

the metal casing of the tower from 

the housing by liftingup the casing 

as shown in the drawing.

Open the door on the front of the RAID Tower Mini 

to reveal the Snap-In Double Drive.

Gently push the silver button on the Snap-In 

Double drive's door to open it.

Push a 2.5" SATA drive into the bay, label side up, 

with the SATA connectors toward the rear. It should 

give little resistance, DO NOT force the drive.

Once the drive has been pushed into the bay 

as far as it will go, close the door over it until the 

door snaps in place.

Slide the storage device into the 

embedded mounting bracket.

Using 3.5” SATA Hard Disk Drives Connect the 

internal SATA data cable to the data port of the 

hard drive then connect the 15-pin SATA power 

connector to the powerport on the hard drive.  

The Snap-In Double Drive is connected to Ports 0 

and 1 on the HPM-XU Port Multiplier. Connect the 

top 3.5" drive to Port 2, the middle drive to port 3, 

and the bottom drive to Port 4.

Secure the hard disk by using screws

provided. Repeat the above procedure for

additional hard drives.

Hard Disk