Справочник Пользователя для Zebra Technologies APL-I
43
Commands
Configuration Commands
11/24/09
APL-I Reference Guide
14177L-003
Print Speed, Set
Purpose To determine the print speed.
Syntax
<SI>Sn
Supported
Based on testing, this command works the same on the Zebra printer with
APL-I firmware as on the 3400D printer.
Notes
Defines the print speed.
Default: n = 30
Values for n: 20, 30, 40, 50 or 60
20 = 2 inches per second (ips), 30 = 3 ips, etcetera.
Printer Language, Select
Purpose To determine the printer language.
Syntax
<SI>ln
Supported
Based on testing, this command works the same on the Zebra printer with
APL-I firmware as on the 3400D printer.
Default Value: n = 0
Default Value: n = 0
Values for n: 0 - 10
Notes
Only one language can be used for a print job. If it is necessary to use more than one
language, you can either bitmap the TrueType fonts or create your own bitmap font. The
default language selection should supply you with the necessary characters for a bitmap.
However, if you are using a TrueType font, it is imperative that you match code to the
language. If you downloaded a scalable font, you must first download the correct code.
default language selection should supply you with the necessary characters for a bitmap.
However, if you are using a TrueType font, it is imperative that you match code to the
language. If you downloaded a scalable font, you must first download the correct code.
Printhead Loading Mode, Select
Purpose To determine the printhead loading mode.
Syntax
<SI>hn,m
Supported
Based on testing, this command works the same on the Zebra printer with
APL-I firmware as on the 3400D printer.
Notes
Printing batches of labels in inverse mode is not recommended due to wear on the
printhead.