Справочник Пользователя для Enterasys Networks 2E253

To configure the Trap table, proceed as follows:

1. Use the arrow keys to highlight the appropriate Trap Destination field.

2. Enter the IP address of the workstation that is to receive traps. IP address entries must follow the 

DDN format. 

For example: nnn.nnn.nnn.nnn

3. Press ENTER. If an invalid entry is entered, the message “INVALID IP ENTERED” displays 

in the Event Message Line.

4. Use the arrow keys to highlight the Trap Community Name field. Enter the community name.

5. Press ENTER.

6. Use the arrow keys to highlight the Enable Traps field. Press the SPACE bar to choose either 

YES (send alarms from the device to the workstation), or NO (prevent alarms from being sent).

7. Use the arrow keys to highlight the SAVE command and press ENTER. The message “SAVED 

OK” displays on the screen.

The designated workstations will now receive traps from the device as long as the communication 
path to the designated workstations is not inhibited (for example, by subnets or VLANs).

Trap Destination 
(Modifiable)

Display/enter the IP address of the workstation to receive trap alarms. 
Up to eight different destinations can be defined.

Trap Community 
Name 
(Modifiable)

Display/enter the Trap Community Name included in the trap message 
along with the IP address of the Network Management Station to 
receive the trap alarm.

Enable Traps 
(Toggle)

Enable/disable the transmission of traps to the network management 
station with the associated IP address. This field toggles between YES 
and NO.

NOTE: Exiting without saving causes a “NOT SAVED?” message to appear above the 
SAVE command. Edits are lost if they are not saved before exiting.