Справочник Пользователя для Enterasys Networks 2E253

To download a firmware image file to the device using Runtime, proceed as follows:

1. Use the arrow keys to highlight the Reboot After Download field.

2. Use the SPACE bar to select either YES or NO. Select YES if you want the device to reboot 

after the download is completed. Select NO if you want the device to store the new image in 
FLASH memory until the device is reset or during the next power-up.

3. Use the arrow keys to highlight the TFTP Gateway IP Addr field.

4. Set the IP address of the TFTP gateway (this defaults to the same IP address as that set in the 

TFTP Gateway IP Addr field on the General Configuration screen). 

5. Use the arrow keys to highlight the Download Server IP field.

6. Enter the IP address of the TFTP server using the DDN format.

For example: nnn.nnn.nnn.nnn

7. Use the arrow keys to highlight the Download File Name field.

8. Enter the complete pathway and file name of the image stored on the download server.

For example: /tftpboot/SS2200.fls

9. Use the arrow keys to highlight EXECUTE at the bottom of the screen and press ENTER. If 

Reboot After Download is set to NO in step 2, the message “RUNTIME DOWNLOAD IN 
PROGRESS” displays in the event message line at the top of the screen and the new image is 
downloaded into FLASH memory. If Reboot After Download is set to YES in step 2, the 
message “REBOOT WILL OCCUR AFTER DOWNLOAD COMPLETES” displays.

During the downloading process, the screen displays the Download Block Count (the number of 
frames received).

To download a configuration file from a TFTP server to the device, proceed as follows:

1. Use the arrow keys to highlight the Download Method field.

2. Use the SPACE bar to select DOWNLOAD CONFIG.

NOTE: When DOWNLOAD CONFIG is selected, the Reboot After Download field is 
automatically set to YES (and cannot be changed), so that the device automatically 
reboots after a successful download.