Справочник Пользователя для Enterasys Networks 2E253

The following describes how to configure a port using the Rate Limiting Configuration screen:

1. To enter a Port Type, proceed to 

. To enter a port number, proceed as follows:

a. Use the arrow keys to highlight the field (1) below the Port Number field.

b. Type in the port number and press ENTER.

c. Proceed to 

Max Rate: kbps
(Modifiable)

Enter the maximum transmission rate for this entry. The maximum 
transmission rate includes all frames associated with the priorities 
selected in the Priority List field. The default is the high setting of 
100 Kbps maximum interface speed. The high range setting is 100 
Kpbs to 1 Gbps. The low range setting is 50 to 40000 Kpbs.

For details on rate limiting, refer to 

NOTE: For further details on configuring the rate limiting range 
on a port, refer to the rate_limit_mode command in 

ADD 
(Command)

Add the current port, priority, and maximum rate selections to the 
screen. For details about how to configure and add an entry, refer to 

DEL ALL/DEL 
MARKED 
(Toggle) 

Delete all or one or more marked entries. The DEL ALL command is 
the default and it is used to simultaneously delete all the lines of 
configured information. The DEL MARKED command appears in 
place of the DEL ALL command when one or more lines are marked 
for deletion. For details on using the two commands, refer to