Справочник Пользователя для Enterasys Networks 2E253

3. Exit from Local Management by repeating steps 1 and 2 until the Device Menu screen displays.

4. To end the LM session, use the arrow keys to highlight the RETURN command at the bottom 

of the Device Menu screen.

5. Press ENTER. The Local Management Password screen displays and the session ends.

If a particular Local Management screen has more than one screen to display its information, the 
NEXT and PREVIOUS commands are used to navigate between its screens. 

To go to the next or previous display of a screen, proceed as follows:

1. Highlight the applicable NEXT or PREVIOUS command at the bottom of the screen.

2. Press ENTER. The screen displays.

The CLEAR COUNTERS

command is used to temporarily reset all counters of a screen to zero to 

allow you to observe counter activity over a period of time. To reset the counters, perform the 
following steps:

1. Use the arrow keys to highlight the CLEAR COUNTERS command.

2. Press ENTER, the counters are reset to zero.

To access the Device Menu screen to start a Local Management session via a Telnet connection or 
local COM port connection. Whenever a connection is made to the switch, the Local Management 
Password screen displays. Before continuing, you must enter a password, which is compared to the 
previously stored passwords and associated management level access policy configured using the 
Security screen described in 

. 

The level of management access is dependent on the password and the associated Access Policy 
configured in the Password Configuration screen described in