Справочник Пользователя для Q-Logic 3000

B–Flash Update
QLogic Adapter Flash Update—Linux

B-8

NE0154601-00  B



To perform updates simultaneously from two different directory trees, type 
the following commands from two separate directory trees. In these 
commands, n represents two different port numbers, for example, “Local 
Area Connection 4” and “Local Area Connection 5” (the 

quotation marks are required). 



c:\[version]-a\utils\ nxflash.exe -i “Local Area 
Connection n” --all (first QLogic adapter)



c:\[version]-b\utils\ nxflash.exe -i “Local Area 
Connection n” --all (second QLogic adapter)

This section describes how to perform a Flash update in Linux. Note that the 
QLogic adapter is shipped with a default Flash version. 

When invoking the nxflash utility, use the following syntax:

% ./nxflash -i [n] [command]

In this command, the [n] indicates the QLogic adapter device number (0, 1, etc.).
Along with the interface type (-i in the nxflash command syntax), additional 

commands ([command] in the nxflash command syntax) are listed in 

.

-l 

--list

List devices

This command shows all QLogic devices 
installed.

-i

--interface

Interface

This command specifies the interface type 
(0, 1, 2, etc.).

--info

Information

This command displays adapter informa-
tion such as the adapter type, chip revision, 
serial ID, firmware version, BIOS version, 
MAC address, etc.

-a

--all

Flash update This command performs a complete 

update of the BIOS and the firmware. This 
command is used when the default ROM 
image is used.