Справочник Пользователя для Q-Logic 2300 series

2 – QCP2330/2332

FCode

CF2351102-00  F

2-11

Q

10. Shut down the system. Type the following:

/sbin/init 0

11. Boot from the newly created boot disk. For example:

boot /pci@1f,0/pci@1/QLGC,qla@4/sd@82,0

The target device ID (sd@82) is in hexadecimal. The decimal value 
is used in 

12. View the current dump device setting. For example:

# dumpadm

Dump content: kernel pages

Dump device: /dev/dsk/c0t0d0s1 (swap)

Savecore directory: /var/crash/saturn

Savecore enabled: yes

13. Change the dump device to the swap area of the new boot drive. For example:

# dumpadm -d /dev/dsk/c3t130d0s1

Steps 

 and 

 set the newly created boot disk as the default boot 

disk. These steps are performed at the system OBP (ok) prompt.

14. Create an alias entry for the new boot device (optional). For example:

ok nvalias fibredisk /pci@1f,0/pci@1/QLGC,qla@4/sd@82,0

15. Set default boot device to be the new boot device (optional). For example: 

ok setenv boot-disk fibredisk 

Use the show-data-rate command to view the current QCP2330/2332 Fibre Channel 
data rate. For example:

ok show-data-rate

Current HBA data rate: One Gigabit rate 

Use the set-data-rate command to change the current QCP2330/2332 Fibre 
Channel data rate. For example:

ok 1 set-data-rate 

Calculating NVRAM checksum, please wait... 

Current HBA data rate: Two Gigabit rate