Справочник Пользователя для Q-Logic 2300 series

3 – QCP2340/2342

FCode

CF2351102-00  F

3-7

Q

3. Set the QCP2340/2342 HBA loop ID 

4. Select the boot device 

5. Build the bootable disk 

.

The QCP2340 has one channel; the QCP2342 has two channels. The code 
distinguishes between the channels as follows:

■

qla@4

 (QCP2340 and QCP2342 (first channel))

■

qla@4,1

 (QCP2342 second channel)

Throughout the FCode sections, the examples use qla@4;substitute qla@4,1 for 
the example to apply to the QCP2342’s second channel.

If you need to update the FCode on the QCP2340/2342 HBA, use the QLogic 
qla2x00 flash utility. A QLogic Solaris SPARC driver revision 3.06 or later must be 
installed before the flash utility can be run.

Be very careful when changing flash contents; incorrect data may 
render the QCP2340/2342 HBA unusable to the point that the 
operating system may no longer function.

Perform the following steps to run the flash utility:

1. Copy the qla2x00flash file and the ifp2312.prom file to the desired directory. 

2. At the command line, enter the appropriate path. Use the information obtained 

with the show-devs command (see 

). For example:

./qla2x00flash -l /devices/pci@1f,0/pci@1/QLGC,qla@4:

devctl ifp2312.prom

For the QCP2342, the second channel must be run as well, for example:

./qla2x00flash -l /devices/pci@1f,0/pci@1/QLGC,qla@4,1:

devctl ifp2312.prom

Perform the following steps to view the current QCP2340/2342 HBA connection 
mode and change it if necessary.

1. To view the current connection mode, type the show-connection-mode 

command: 

ok show-connection-mode