Справочник Пользователя для Sim2 Multimedia SVP 420 HB

SVP 450 PLUS - SVD 500 PLUS

17

ENGLISHENGLISHENGLISHENGLISHENGLISH

-

If the measurement of the screen diagonal is not in
the table, C can be determined  (in cm) as follows.

-

Measure the screen diagonal and take the nearest
value from the table.

-

Calculate the ratio between value C and screen width
in the table.

-

Multiply the result by the actual screen width.

Suppose we have a 105” screen diagonal. 100”

is the nearest value in the table.
Ihe C/Width ratio is equal to :305/203.2=1,5.
A105” screen diagonal is 213.3 wide.
So, the value of C is:  1,5x213,3=320 cm.

The use of the correct spacers as shown in the
spacers table is mandatory for a perfect focus
uniformity.
Use the ceiling assembly kit (given with the projector) to
install the projector on the ceiling and proceed as follows:

The installer must verify that the ceiling can
support the projector load. The bracket must
be fixed properly and be absolutely parallel
with the screen

MURO

1- Fix the bracket, included in the pack, to the ceiling with

the four screws supplied.

2- Put the projector on a table in the vertical position

(sideways)

3- Fasten the left bracket with 2 screws and washers.

4- Repeat the steps above for the right bracket.