Справочник Пользователя для Furman Sound P-8 PRO II
pro SErIES II 20 amp powEr CondItIonErS
WA R N I N G
To reduce the risk of electrical shock, do not
expose this equipment to rain or moisture.
Dangerous high voltages are present inside the
enclosure. Do not remove the covers. refer
servicing to qualified personnel only. The
lightning flash with an arrowhead symbol, is
intended to alert the user to the presence of
un-insulated dangerous voltage within the
product’s enclosure that may be of sufficient
magnitude to constitute a risk of electric shock.
I M P o r TA N T S A F E T Y
I N S T r U C T I o N S
(Please read prior to installation)
1. Please read and observe all safety and
operating instructions before installing your
Series II unit. retain these instructions for
future reference.
2. The unit should not be used near water – for
example, near a bathtub, washbowl,
kitchen sink, laundry tub, in a wet basement,
near a swimming pool, etc.
3. Do not place your unit near heat sources
such as radiators, heat registers, stoves, or
other appliances that produce heat.
4. The units should only be connected to a
120 VAC, 60Hz, 20 amp grounded electrical
outlet. Do not defeat the ground or change
polarization of the power plug.
5. route the power cord and other cables so
that they are not likely to be walked on, tripped
over, or stressed. Pay particular attention to
the condition of the cords and cables at the
plugs, and the point where they exit your Pro
Series II unit. To prevent risk of fire or injury,
damaged cords and cables should be replaced
immediately.
6. Clean your Series II unit with a damp cloth
only. Do not use solvents or abrasive cleaners.
Never pour liquid on or into the unit.
7. Your Pro Series II unit should be serviced by
qualified service personnel when:
• The power supply cord or the plug has been
frayed, kinked, or cut.
• Objects have fallen or liquid has spilled into
the unit.
• The unit has been exposed to rain or other
moisture.
• The unit does not appear to operate normally.
• The “Protection OK” indicator is not lit.
• The unit has been dropped, or the enclosure
has been damaged.
• The retractable LED lights have failed.
(not
applicable to the P8-PRO II)
8. Your Pro Series II unit requires that a safety
ground be present for proper operation. Any
attempt to operate the unit without a safety
ground is considered improper operation and
could invalidate the warranty.
9. Do not attempt to service your Pro Series II
unit beyond what is described in this manual.
All other servicing should be referred to
qualified service personnel.
ADDITIoNAL F E A T U r E S
PL-8 Pro Series II
The PL-8 Pro II features LED rack lights
which produce virtually no heat and provide
an extremely long life span. A dimmer control
for the rack lights allows the user to adjust the
level of illumination or simply switch the lights
off. A rear mounted BNC jack accepts any
standard (12VAC 0.5 amp) gooseneck lamp for
rear rack illumination.
2