Справочник Пользователя для Panasonic PT-FW300U
E
NGLISH - 41
Settings
PROJECTOR SETUP menu
You can see the status of the projector about the
following items.
following items.
You can switch the function of the COMPUTER2 IN/
1 OUT terminal.
1 OUT terminal.
INPUT
COMPUTER2 IN
OUTPUT
COMPUTER1 OUT
You can set the timer to switch off the power of the
projector after a certain period of time automatically
when no signal is detected. Press
projector after a certain period of time automatically
when no signal is detected. Press
I H to select the
required period from 15 to 60 minutes at intervals of
5 minutes.
5 minutes.
You can select how the projector start when the power
cord is connected.
cord is connected.
STATUS
Items
Description
Q SIGNAL
NAME
Projecting signal name
FREQUENCY
Projecting signal frequency
Q RUNTIME
PROJECTOR
Duration of projector used time
LAMP
Duration of lamp used time
Q REMAINING FILTER
QUANTITY
Quantity of filter remaining
APPROX.TIME
Approximately time of filter
remaining
remaining
NOTE:
• QUANTITY and APPROX.TIME of REMAINING
FILTER is not the accurate but the calculated and
predicted result based on the filter rolling pace.
Incorrect remaining time could be displayed briefly;
such as suddenly shortened or stays same for a while.
predicted result based on the filter rolling pace.
Incorrect remaining time could be displayed briefly;
such as suddenly shortened or stays same for a while.
• Replacement of the Auto Cleaning Filter (ACF) needs
to be prepared when the QUANTITY and
APPROX.TIME of REMAINING FILTER becomes few.
APPROX.TIME of REMAINING FILTER becomes few.
Remote control
Control panel
COMPUTER2 SELECT
NO SIGNAL SHUT-OFF
DISABLE
FG
FG
15 MIN.
60 MIN.
FG
FG
20 MIN.
55 MIN.
FG
FG
25 MIN.
50 MIN.
FG
FG
30 MIN.
45 MIN.
FG
FG
35 MIN.
IH
40 MIN.
INITIAL START UP
Options
Description
LAST MEMORY
Start as the same mode as the
last switched off.
last switched off.
STANDBY
Always start in standby mode.
ON
Always start in projecting
mode.
mode.