Справочник Пользователя для Panasonic PTDW740ULK
![Panasonic](https://files.manualsbrain.com/attachments/8f677e63fb64cbb6c62d09e6242996e7631380a8/common/fit/150/50/34d700d3fb727c767799b2da5cc474b219c0a4312e9e3044c99491a2fb9a/brand_logo.png)
124 - ENGLISH
Chapter 6 Appendix — Technical information
<REMOTE 2 IN> terminal
It is possible to control the projector remotely (by external contact) from a control panel located away from the projector where remote control
signals cannot reach. Use the <REMOTE 2 IN> terminal on the connecting terminals of the projector to connect to the control panel.
RGB1
VIDEO
RGB2
S-VIDEO
DVI-D
HDMI
Remote control
Contact control
Remote control/Contact control
Standby
Lit
Lamp
Meeting room or other installation location
Remote control panel in another location
Pin assignments and signal names
D-Sub 9-pin (Outside view)
Pin No.
Signal name
Open (H)
Short (L)
(1)
(5)
(6)
(9)
(1)
GND
―
GND
(2)
POWER
OFF
ON
(3)
RGB1
Other
RGB1
(4)
RGB2
Other
RGB2
(5)
VIDEO
Other
VIDEO
(6)
S-VIDEO
Other
S-VIDEO
(7)
DVI-D
Other
DVI-D
(8)
SHUTTER
OFF
ON
(9)
RST/SET
Controlled by remote
control
Controlled by external
contact
Attention
r
f
When controlling, make sure to short-circuit pins
(1) and (9).
r
f
When pins
(1) and (9) are short-circuited, the following buttons on the control panel and the remote control cannot be used.
The power on <b> button, the power standby <v> button, the <SHUTTER> button, and the RS-232C commands and network functions
corresponding to these functions cannot be used either.
r
f
When pins
(1) and (9) are short-circuited, do not short-circuit any pins from (3) to (7) with pin (1). The following buttons on the control panel
and the remote control cannot be used.
The power on <b> button, the power standby <v> button, <RGB1> button, <RGB2> button, <DVI-D> button, <VIDEO> button, <S-VIDEO>
button, <HDMI> button, <SHUTTER> button, and the RS-232C commands and network functions corresponding to these functions cannot
be used either.
Note
r
f
For pin
(2) to pin (8) settings, you can make changes if you set [REMOTE2 MODE] to [USER] (x page 81).