Справочник Пользователя для Jenn-Air 800

Do not place excessive weight on or stand on an open
oven door. This could cause the range to tip over, break
the door, or injure the user.

1. Do not use abrasive cleaning agents such as steel wool

scouring pads or powdered cleansers as they may scratch
the glass.

2. Do not hit the glass with pots, pans, furniture, toys, or other

objects.

3. Do not close the oven door until the oven racks are in

place.

Scratching, hitting, jarring or stressing the glass may weaken
its structure causing an increased risk of breakage at a later
date.

Note: The oven door on a new range may feel “spongy”
when it is closed. This is normal and will decrease with use.

LEVELING LEG

Be sure the anti-tip bracket secures one of the rear
leveling legs to the floor. This bracket prevents the range
from accidentally tipping.

The range should be leveled when installed.  If
the range is not level, turn the plastic leveling
legs, located at each corner of the range, until
range is level.

ANTI-TIP BRACKET

• Disconnect power to range before replacing light bulb.

• Allow oven to cool before replacing light bulb.

• Make sure bulb cover and bulb are cool before touching.

(Canadian models only)

The convenience outlet is located
on the lower left side of the
backguard. Be sure appliance cords
do not rest on or near the surface
element. If the surface element is
turned on, the cord and outlet will
be damaged.

The convenience outlet circuit
breaker may trip if the small
appliance plugged into it exceeds
10 amps. To reset the circuit
breaker, press the switch located
on the lower edge of the backguard.

CIRCUIT BREAKER

1. When oven is cool, hold bulb cover

in place, then slide wire retainer
off cover. NOTE: Bulb cover
will fall if not held in place
while removing wire retainer.

2. Remove bulb cover and light

bulb.

3. Replace with a 40-watt appliance bulb.

4. Replace bulb cover and secure with wire retainer.

5. Reconnect power to range. Reset clock.

8113P417-60B

9/28/04, 11:40 AM

28