Справочник Пользователя для Emerson 210-2002

 

 

Product Information Sheet

210-2002

       Input Status Screen

The 210-2002 is a Vaporstat™ wall-mounted 
dewpoint sensor. The sensor is designed for 
measuring indoor or outside dewpoint or absolute 
humidity level.  
 

 

1. For wiring the dewpoint sensor to a CPC 

input board, use Belden #8761 shielded two-
conductor cable or equivalent. 
 

2. Connect the BLACK and WHITE wires to the 

screw terminals on the sensor’s connector as 
shown in 

Figure 1 (connect BLACK to Signal 

Ground and WHITE to 0-5V Output). Clip the 
SHIELD wire. 

 
 
 
 
 
 
 
 
 
 
 
 
 
 

3. Connect the SHIELD and BLACK wires to the 

0V terminal of the input board. Connect the 
WHITE wire to the SIG terminal of the input 
board. 
 

4. Connect 24VAC (a separate 120VAC/24VAC 

transformer must be used P/N 640-0039) to 
the power terminal on the dewpoint sensor 
back plate using the BLACK and WHITE wires. 
(This 24VAC transformer must only be used 
to power this dewpoint sensor. Do not use 

this transformer to power additional 
devices.) 

 

5. Locate the input dip switch for the sensor 

point, and set to the OFF position (LEFT for 
MultiFlex, DOWN for 16AI). Refer to the input 
board’s user manual for locations of the 
input dip switches. 

 
NOTE:  DO NOT set this sensor up with a sensor type 

of “Dewpoint”; that setting is only for CPC 
Dewpoint Probes (P/N 203-1902). This 
dewpoint sensor MUST be set up as a linear

 

 

sensor type. 

E2/Einstein 

 

1. After logging  into the   controller,   press                                    

6

 + 

 to open the Input Status screen or 

press the 

I

 key, 

 (System 

Configuration), 

 (Input Summary). (If 

using an Einstein, press F8(ACTIONS) from 
the  Home screen.  Press Y (System  Setup).   
Press 6 (Input and Output Point Setup).  
Press 1 (Input  Summary) to open the Input 
Summary screen.) 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

Product Information Sheet