Справочник Пользователя для Ingersoll-Rand 4581740

04581740_ed2 

29

The Statistics menu allows you to access a variety of statistical data on completed fastenings. For example, you can view 

actual fastening parameters, as well as statistical calculations, and can compare them to target values.

This section discusses the four Statistics sub-menu screens, including:

Figure 25 - Statistics Menu

The Cycle Log is a view-only screen that displays various tightening parameters that are monitored during a fastening. 

Up to a maximum of 1,000 of the most recent cycles for the IC-D and 200 for the IC-M are stored in the respective 

controllers. This screen displays cycle data for every Configuration used, but note that the torque value shown reflects 

whatever unit of measurement (Nm, Ft-lbs, etc.) was selected for a particular Configuration.

Figure 26 - Cycle Log

The Cycle Log table parameters include Cycle Number, the Configuration # that was in effect for that cycle, the 

Torque value, the Angle value, and the SD Code. The Configuration # is found under the icon over the second column 

in the header of the Cycle Log. 

When the torque and angle values for a cycle are within the programmed range, nothing appears in the column next 

to those two values. However, if the values are high or low, the arrow symbols seen on the Main screen are displayed 

in this column to represent a deviation from the norm. See cycles 467 and 468 in the above figure for examples of high 

and low icons on this screen. 

•
•
•
•