Справочник Пользователя для Bosch sHX33M

Rinse Agent Dispenser
open the rinse agent dispenser by lifting the tab with your thumb as shown in

 figure 17.

NOTE: the dishwasher indicates low rinse agent either by showing the symbol  

 in the 

countdown display, or illuminating the refill rinse agent light (model dependent).
add liquid rinse agent to the dispenser as shown in figure 18 until the rinse agent reservoir 
is full. Wipe up any excess rinse agent that puddles when the dispenser reservoir is full.
NOTE: After filling the rinse agent dispenser, the  indicator light will go out in a few 
minutes after the dishwasher door is shut (select models only).

always make sure your dishware is dishwasher safe. refer to the 

Dishware Materials 

section of this manual for guidance.

Wash Cycles (See Cycle Chart)

Cleans items having baked-on or hard dried-on food soils. these items may require soaking 
or hand scouring.

thoroughly cleans large loads having loosely attached normal soiling.

for delicate or heirloom dishwasher and silverware or other special items. always make 
sure that the items are dishwasher safe. refer to the Materials section of this manual for 
further information. Hand washing may be the best treatment of such items.

for lightly soiled items with easy to remove food soils.

allows you to rinse the food soil off of a partial load and hold them in the dishwasher until 
there is a full load.

Wash Cycle Options

in the power scrub plus, regular and auto Wash cycles you can reduce the energy and 
water consumption when washing small, lightly soiled loads that fill approximately half of 
the dishwasher’s capacity. to activate, select the Half load button in addition to the power 
scrub plus, regular or auto Wash cycle button.

this Cycle Completion signal is a tone that sounds to alert you when your dishwasher 
finishes washing and drying your dishes. You can either disable the tone or set the volume.

to activate:

·  press and hold the right “Cancel Drain” button then press and hold the on/off button.

·  When the light on the “Cancel Drain” button you are pressing illuminates and the tone 

begins to sound, release both buttons.

·  press the right-most “Cancel Drain” button until the tone is either at the desired 

volume or is silent.

·  press the on/off Button. the Cycle Completion signal is now set.