Справочник Пользователя для Bunn FMD-5

46

FIG. 43 COLD WATER SOLENOID TERMINALS

P1215

FIG. 42 COLD WATER SOLENOID VALVE

Location:

The cold water solenoid valve is located on the left 

side of the dispenser base just behind the component 

bracket.

Test Procedures:

1.   Disconnect the dispenser from the power source.

2.  With the “HOT/COLD” switch in the “COLD” (upper) 

position press any left dispense switch on front of 

the door.

3.  With a voltmeter check the voltage across the white 

and white/yellow wires at the solenoid terminals. 

Connect the dispenser to the power source. The 

indication must be:

 

a) 120 volts ac for two wire 120 volt models

 

b) 120 volts ac for three wire 120/208 or 120/240 

volt models

 

c) 240 volts ac for two wire 240 volt models.

 

d) 230 volts ac for two wire 230 volt models.

4.  Disconnect the dispenser  from the power 

source.

If voltage is present as described, proceed to #5

If voltage is not present as described, refer to wiring 

diagram and check dispenser wiring harness.

5.  Disconnect the white and white/yellow wires from 

the solenoid. 

6.  Check for continuity across the solenoid valve coil 

terminals.

If continuity is present as described, reconnect the 

white and white/yellow wires to the solenoid.

If continuity is not present as described, replace the 

solenoid valve.

7.  Check the solenoid valve for coil action. Connect the 

dispenser to the power source. With “HOT/COLD” 

switch in the “COLD” (upper) position press the left 

dispense switch and listen carefully in the vicinity 

of the solenoid valve for a “clicking” sound  as the 

coil magnet attracts.

8.  Disconnect the dispenser from the power source.

If the sound is heard as described and water will not 

pass through the solenoid valve, there may be a block-

age in the water line before the solenoid valve or, the 

solenoid valve may require inspection for wear, and 

removal of waterborne particles.

If the sound is not heard as described, replace the 

solenoid valve.

Removal and Replacement:

1.  Loosen the two screws securing the component 

bracket to the dispenser base. Lift the component 

bracket off of the base and move to the right.

2.  Remove the white and white/yellow wires from the 

solenoid valve.

3.  Turn off the water supply to the dispenser.

4.  Disconnect the water lines to and from the solenoid 

valve.

5.  Loosen the two #8-32 screws and washers secur-

ing the solenoid mounting bracket to the base. 

Remove solenoid bracket and solenoid valve as an 

assembly.

6.  Remove the two #10-32 screws and lockwash-

ers securing the solenoid valve to the solenoid 

bracket.

7.  Using two #10-32 screws and lockwashers install 

new solenoid valve on solenoid mounting brack-

et.

8.  Install the solenoid valve and bracket on the dis-

penser base and tighten the two #8-32 screws.  

9.  Securely fasten the water lines to and from the 

solenoid valve.

10. Refer to schematic wiring diagrams when recon-

necting the wires.

P4102.40

42672 122209