Листовка для Quantum Fireball ST

 
 

Fireball ST 

Mounting Guidelines 

 

 

 
 
Mounting Screw Tap Locations 
The mounting holes on Quantum 3.5-inch form factor hard disk drives allow the drive to be mounted in any 
orientation. The figure provided identifies the location of the three mounting holes found on each side of the drive 
and the four mounting holes found on the PCB side of the drive. Dimensions given are in inches and millimeters. 
 

 

 
Mounting Screw Clearance  
Please note that the printed-circuit board assembly (PCBA) is very close to the mounting holes. For mounting #6-
32 UNC screws are recommended. Mounting screws should be no longer than 0.25 inches (6.35 mm) and 
maximum torque applied to the screws must not exceed 8 inch-pounds. Clearance from the drive to any other 
surface (except mounting surfaces) must be a minimum of 0.05 inches (1.25 mm).  
 

 

 
 

1 of 1