Справочник Пользователя для Smeg CS15-5

 

8

 

 

  2.4.2

 

 

 

 

  For butane, use a pressure regulator on the gas cylinder in accordance with the 

regulations in force and a flexible hose in accordance with Standard XPD36-110. 
Screw hose-end fitting A onto the end of pipe B of the appliance, interposing seal 
C between the two, carefully thread on flexible hose D and fix the hose to the 
hose-end fitting using safety collar E. The flexible hose may only be used if the 
appliance has been installed in isolation from the network or if the full length of the 
hose is visible. For propane, see paragraph “2.4.3 Connection using a collapsible 
steel tube”. 

 

   

 

  2.4.3

 

  The gas can be connected using a flexible rubber hose (Standards NFD36-100 

and NFD36-103 for methane; Standard XPD36-112 for butane) or using a 
collapsible metal tube (Standard NFD36-121 for methane; Standard NFD36-125 
for liquid gas). Where a flexible rubber hose is used, please observe the 
requirements set out in the paragraph marked "Important". 
The connection point on the appliance is a threaded ½” male gas connection. 

 

   

 

  2.4.4

 

  The gas can be connected using a flexible rubber hose (Standards NFD36-100 

and NFD36-103 for methane; Standard XPD36-112 for butane) or using a 
collapsible metal tube (Standard NFD36-121 for methane; Standard NFD36-125 
for liquid gas). Where a flexible rubber hose is used, please observe the 
requirements set out in the paragraph marked "Important". 
Flexible hose/collapsible tube L must be connected directly to the end of pipe B 
of the appliance, interposing seal C between the two. The connection point on 
the appliance is a threaded ½” male gas connection. 

 

 

 

 

  2.4.5

 

 

 

 

Use a pressure regulator in accordance with the regulations in force and carry out the connection to 
the cylinder in accordance with the regulations in force. Make sure that the feed pressure is in 
accordance with the values specified in the table in paragraph "3.2/3.3 Tables for burner and injector 
characteristics" 

 

 

   

Screw hose guide F onto hose guide A; connect the resulting assembly 
to gas fitting B (or use hose guide G which must be connected directly to 
gas fitting B) and interpose seal C in between the two. Mount the ends of 
rubber hose H onto hose guides A+F (or G if appropriate) and the outlet 
fitting of the pressure regulator onto the cylinder. Fix the ends of hose H 
onto hose guides A+F (or G if appropriate) using bearing I in accordance 
with the regulations in force.