Справочник Пользователя для Panasonic SA-XR58
ENGLISH
RQTV0156
14
Before playback
Before playback
Auto speaker setup
Auto speaker setup allows you to achieve a satisfactory listening environment easily with the use of the supplied calibration
microphone as a detector of sound signals. The unit will first perform automatic speaker detection, then checks and adjusts the
following settings.
2
Process for auto speaker setup
Connect the calibration microphone to the [SETUP
MIC] jack on the front panel.
The calibration microphone is sensitive to heat. Keep it away from direct
sunlight and do not place it on top of the unit.
Placing of calibration microphone.
Place on a flat surface at the seating area. Use a tripod for best results.
1
Note
Before setup
Conduct the auto speaker setup in a quiet environment. A noisy background will give unsatisfactory results.
Put the subwoofer in position, switch it on, and sets its volume to the level you would normally use. If you do auto speaker setup
without the subwoofer, the front speakers will be set as large, possibly resulting in an unsatisfactory bass.
•
•
Automatic speaker detection
(This can also be performed in
“Automatic speaker detection”,
➡
page 17. However, for a
more optimized listening
environment, carry out the
setup here.)
Checks which speakers you have connected.
The factory setting is 7 speakers and a subwoofer.
Some types of speakers and cables may cause disruptions to the setup. In this case, conduct
manual setting, “Speaker and size settings”,
➡
page 27.
•
•
•
DISTANCE
Checks the distance of each speaker from the listening position and adjusts the timing of each
channel. For manual setup, “Distance”,
➡
page 27.
•
POLARITY
Checks the polarity of each speaker. You can choose not to have polarity checked, “Auto
setup”,
➡
page 27.
•
SIZE
Checks the speaker’s frequency response. For manual setup, “Speaker and size settings”,
➡
page 27.
The front speakers are set to SMALL if the unit determines that they are different sizes.
•
•
FREQUENCY
Sets the appropriate low frequency crossover for each channel according to the speaker size.
For manual setup, “Low-pass filter”,
➡
page 27.
The setting is based on the speaker with the lowest bass reproduction range.
Also checks on
“Level” setting to adjust the sound level (volume) for each speaker.
•
•
•
LEVEL
Makes any further corrections to the volume of each speaker (for manual setup, “Speaker output
and level”
➡
page 17) and also to the frequency response.
•
AUTO
SPEAKER SETUP
ADVANCED
DUAL AMP BI-AMP
SPEAKERS
A
B
AUTO DETECTOR
SURROUND
AUX
SETUP MIC
MENU
SETUP
RETURN
INPUT SELECTOR
ENTER
VOLUME
HDMI
TUNE
S VIDEO IN VIDEO IN L AUDIO IN R
SA-XR58.indb 14
6/27/2006 6:54:58 PM