Справочник Пользователя для Mitsubishi Electronics C6/C64

 
 

I - 17 

 

Each unit is installed in the sealed structure cabinet as a principle. When installing into the cabinet, refer 
to the following drawings to consider the control unit's heat radiation and wiring, and secure enough 
space for ventilation. 

(1)  Install each unit vertically so that the front is visible. 
(2)  Refer to the following drawings to consider the control unit's heat radiation and wiring, and secure 

enough space for ventilation. 

 

d 

(Top)

(Bottom)

Servo drive unit

Spindle drive unit Power supply unit

 

Control unit 

50mm or more 
(heat dissipation, 
wiring allowance) 

*10mm or more
when there is a 
unit on the left 

100mm or more   

(heat dissipation,   

wiring allowance)

 

10mm or more 

(heat dissipation, 

wiring allowance)

MITSUBISHI 

MELDAS 

C64 

50mm or more 

(heat radiation 

allowance) 

 

 

(Note)  The right side of the control unit will temporarily expand by approx. 2mm when the 

expansion card is inserted and removed. 

 

It will not be possible to insert or remove the expansion card if there is no space between 
the control unit and adjacent unit. Always provide sufficient space. 

 

 Install the control unit and communication terminal on noncombustible material.  

 

  Always observe the installation direction. 

 

  Do not install or operate a control unit or communication terminal that is damaged or that 

 

  The control unit and communication terminal are precision devices so do not drop or