Справочник Пользователя для Jacuzzi J-345
25
J-300
10.0 Operating Instructions
The spa control system has automatic functions that operate upon
start-up and normal operation to protect the system. Upon power up, the
readout displays the following information:
1. Control panel displays current software release, then;
1. Control panel displays current software release, then;
2. Control panel displays “888” and all indicator LEDs are lit, permit-
ting visual inspection of all display segments and indicator lights for
proper operation.
3. After the initial start-up sequence ends, the actual water temperature
is displayed. If water temperature, at this time, is less than the fac-
tory default temperature setting of 100°F (38°C) the heater will turn
on and run until the water temperature rises to the factory setting,
then turn off.
Note: It is common for the heater to turn on after the spa is first filled
because tap water is often very cold.
10.1 Setting Water Temperature
10.1 Setting Water Temperature
Press either the
Warmer ( ) or Cooler ( ) button to
adjust the current temperature setting. The current set tem-
perature reading will blink once to indicate
that the system is ready to accept changes.
Press the
Warmer or Cooler button to
adjust the temperature to a desired setting.
Once the desired temperature is reached,
do not press any buttons on the control
panel for about 5 seconds. The new tem-
perature setting will blink twice to indicate
that the change has been made.
To access the overtemp feature that allows the spa to reach 106°F
(41°C) follow the steps below (Figure 1).
WARNING:
RISK OF HYPERTHERMIA (OVER-HEATING)
CAUSING SEVERE INJURY, BURNS, WELTS OR DEATH!
Water temperature in excess of 104°F (40°C) may be injurious
to your health.
!
A. Press and hold the
WARMER ( ) button then;
B. Press and hold the
JETS 1 (
) button at the same time for 2
seconds. You will see the temperature change to 105°F (40°C) on
the LED display. Press the
WARMER ( ) to raise the temperature
to 106°F (41°C) To lower the temperature, press the
COOLER ( )
button.
C. When the overtemp has been activated, the decimal point after the
last digit will flash on and off every second as an indicator for being
in the overtemp mode.
Note: Once the temperature goes below 104°F (40°C) and you would
like to raise the temperature to 106°F (41°C) again, you will have to
repeat the steps above.
1
2
Figure 1