Дополнительное Руководство для Hoshizaki rf28a

40

12) Replace the parts and panels in their proper positions in the reverse order of which 

they were removed. Be sure to clip the clogged filter thermistor in the same location as 
previous.

13) Plug in the unit, and turn on the power supply.

Remove old gasket by pulling it directly out of the vinyl gasket retainer. Thoroughly clean 
the gasket area with mild soap and water prior to installing the new gasket. The new 
gasket should be installed by assembling it at the corners first, then working toward the 
center at the top, bottom and sides. The arrow-shaped portion of the gasket should be 
firmly seated in the retainer groove for proper assembly. This can be checked by lifting 
the edge of the gasket and observing the engagement.

In order to get a proper gasket fit, it is important not to stretch gasket material 
during assembly.

When receiving a service call, please ask the customer to turn the power off, 
then turn it back on and monitor the condition for awhile. Even if the control 
board malfunctions for some reason, it may resume normal operation after the 
power is turned off once.

1. Fragile, handle very carefully.
2. A control board contains integrated circuits, which are susceptible to failure 

due to static discharge. It is especially important to touch the metal part of 
the unit when handling or replacing the board.

3. Do not touch the electronic devices on the board or the back of the board to 

prevent damage to the board.

4. Do not fix the electronic devices or parts on the board in the field. Always 

replace the whole board assembly when it goes bad.

5. Do not short out power supply to test for voltage.
6. Keep the thermistors, clogged filter sensor leads, and pressure switch leads 

at least 1.5" away from high voltage leads (AC 100 volts or more) to protect 
against electrical noise. 

1) Turn off power and unplug the unit.
2) Open the front panel and the control box.
3) Unhook all wiring connections to the control board.