Инструкция для Sony CCD-TRV128
Playback
40
* When there is an S video jack on the device to be
connected, connect the S video plug to that jack
instead of using the yellow video plug. The audio
will not be output when you connect with the S video
plug alone.
Pictures can be reproduced more faithfully with this
connection.
instead of using the yellow video plug. The audio
will not be output when you connect with the S video
plug alone.
Pictures can be reproduced more faithfully with this
connection.
When your TV is connected to a VCR
Connect your camcorder to the LINE IN input
on the VCR using the A/V connecting cable. Set
the input selector on the VCR to LINE.
on the VCR using the A/V connecting cable. Set
the input selector on the VCR to LINE.
To connect to a TV without audio/video
input jacks
input jacks
For TRV128/228/328/428:
Use a NTSC system RFU adaptor (optional).
Refer to the operating instructions of your TV
and the RFU adaptor.
Use a NTSC system RFU adaptor (optional).
Refer to the operating instructions of your TV
and the RFU adaptor.
When your TV is stereo
For TRV128/228/328/428:
Connect the audio plug of the A/V connecting
cable to the left (white) input jack of your TV.
Connect the audio plug of the A/V connecting
cable to the left (white) input jack of your TV.
When your TV is monaural (When your
TV has only one audio input jack)
TV has only one audio input jack)
For TRV260/265:
Connect the yellow plug of the A/V connecting
cable to the video input jack and connect the
white or the red plug to the audio input jack of
your TV or VCR.
When you want to play the sound in monaural
mode, use a connecting cable (optional) for that
purpose.
Connect the yellow plug of the A/V connecting
cable to the video input jack and connect the
white or the red plug to the audio input jack of
your TV or VCR.
When you want to play the sound in monaural
mode, use a connecting cable (optional) for that
purpose.
Locating a scene on a
tape for playback
tape for playback
(
TRV265)
Searching quickly for a desired
scene – Zero set memory
scene – Zero set memory
1
During playback, press ZERO SET
MEMORY on the Remote
Commander at the point you want to
locate later on.
MEMORY on the Remote
Commander at the point you want to
locate later on.
The tape counter is reset to “0:00:00” and
appears on the screen.
If the tape counter is not displayed, press
DISPLAY on the Remote Commander.
DISPLAY on the Remote Commander.
2
Press STOP when you want to stop
playback.
playback.
3
Press m REW.
The tape stops automatically when the tape
counter reaches “0:00:00.”
counter reaches “0:00:00.”
4
Press PLAY.
The playback starts from the point
designated “0:00:00” on the tape counter.
designated “0:00:00” on the tape counter.
To cancel the operation
Press ZERO SET MEMORY on the Remote
Commander again.
Commander again.
PLAY
ZERO SET MEMORY
DISPLAY
STOP
m
REW