Руководство Пользователя для Sony PDW-F330L

164

Maintenance

  

A

turn the control counterclockwise as seen from the 
camcorder front.

Turn the MONITOR knob and check that the speaker 
volume changes accordingly.

Connect an earphone to the front or rear EARPHONE 
jack. 

Check that the speaker sound is cut off and that you 
can hear the sound from the microphone in the 
earphone.

Turn the MONITOR knob and check that the earphone 
volume changes accordingly.

Connect external microphones to the AUDIO IN CH-
1 and CH-2 connectors.

Set the +48V/OFF switches as follows.

• If the connected microphone is of the internal power 

supply type, set the switch to OFF.

• If the connected microphone is of the external power 

supply type, set the switch to +48V.

Set the AUDIO IN switches to REAR.

Aim the microphones at a sound source.

Check that the audio level meters in the LCD monitor, 
and the audio level indications in the viewfinder 
change with the volume of the sound.

Set the user bits as required.

For the operation, see “To set the user bits” on 
page 67.

Set the timecode.

For the operation, see “To set the timecode” on 
page 66.

Set the F-RUN/SET/R-RUN switch to R-RUN.

Press the REC button, and check that recording starts 
and that the timecode indication in the time counter 
display section changes.

Press the REC button again, and check that recording 
stops and that the timecode indication stops changing.

Set the F-RUN/SET/R-RUN switch to F-RUN, and 
check that the timecode indication starts changing 
again and continues to change even when you restart 
recording and stop recording again.

Set the COUNTER/CHAPTER button to U-BIT, and 
check that the user bits data that was set is displayed.

Use a dust blower to clean the CRT screen and mirror 
inside the viewfinder barrel.
Clean the lens and protecting filter with a commercially 
available lens cleaner.