Руководство Пользователя для Sony PDW-F330L

42

Adjusting the Viewfinder

  Chap

te

r 2 

 Pr
epa

ra

tio
n

s

Depending on the eyesight of the operator — whether 
longsighted or shortsighted — the optimal position of the 
viewfinder image varies. Adjusting brightness, contrast, 
and so on, improves the visibility of the viewfinder screen.
Although these adjustments may make the viewfinder 
image clearer, they have no effect on the output video 
signal from the camcorder.
(The description shown below uses the DXF-801/801CE 
illustrations; it also applies to the DXF-20W.)

Since the fitting dimensions are different on the camera 
and viewfinder, to attach a DXF-20W (not supplied) to the 
PDW-F330, it is necessary to change the fitting (supplied 
with the DXF-20W).

Remove any microphone from the viewfinder beforehand.

Power off this unit, then unplug the viewfinder 
connector from the VF connector.

Loosen the viewfinder left-to-right positioning ring 
1

, and with the stopper raised 2, detach the 

viewfinder 3.

Reverse the detaching procedure. (Note that it is not 
necessary to raise the stopper.)

Note the following points when mounting the viewfinder.
• Be sure to power off this unit before plugging the 

viewfinder connector into the VF connector on this unit. 
If the connector is plugged in while the power is on, the 
viewfinder may not operate correctly.

• Make sure that the viewfinder connector is pushed fully 

into the VF connector on the unit. If the connector is not 
firmly connected, the image may break up, or the tally 
light may not operate properly.

By fitting a left eye adaptor, you can use the camcorder 
with your left eye to the viewfinder.

You cannot stow the camcorder in the carrying case with 
the left-eye adaptor attached.

To adjust the viewfinder left-to-right position, loosen the 
left-to-right positioning ring, and to adjust the front-to-
back position, loosen the front-to-back positioning knob.

VF connector

2

3

1

Viewfinder left-to-right 
positioning ring

Stopper