Инструкция С Настройками для Konica Minolta 5D

This section contains operation and compatibility information with camera accessories. Please read
it in its entirety to achieve the best results with your camera.

Lens shadowing occurs when the lens or lens hood blocks part of the output from the built-in flash.
Lens shadowing appears as a semi-circular shadow at the bottom (horizontal pictures) or side
(vertical pictures) of the image. Remove the lens hood before using the built-in flash. Focus distance
must be 1m / 3.3ft or greater. The built-in flash can not be used with the AF 600mm f/4 Apo G(HS). 

All Konica Minolta AF lenses are compatible with this camera. MD and MC series lenses cannot be
used. For our current line of lenses, contact your Konica Minolta dealer.

The AF Macro Zoom 3X - 1X f/1.7-2.8 cannot be used with Anti-Shake (p. 32); turn Anti-Shake off. If
a lens is equipped with a macro release, the release cannot be used with Anti-Shake. Focus range
limiters set to a range that does not include infinity cannot be used. The focus range limiter on the
SSM-series or D-series macro lenses can be used at any set range. Anti-Shake may not work with
products made by another manufacturer.

Because the CCD is smaller than a 35mm frame, the angle of view obtained at a specific focal
length is not the same. To calculate the approximate equivalent 35mm focal length, multiply the
focal length in use by 1.5. A 100mm lens gives about the same angle of view as a 150mm lens on a
35mm camera.

For some technical photographic applications such as macro
photography, the position of the CCD plane is necessary. The
illustration shows the approximate location of the CCD plane.

The supplied eyepiece cap prevents light from entering through the viewfinder and affecting the
exposure meter or fogging the image when using the self-timer or during long exposures.

Carefully slide the eyepiece cup from around the
viewfinder frame by pushing on each side of the cup.

Slide the eyepiece cap over the viewfinder. The cap
should be attached to the camera strap to prevent loss.
Replace the eyepiece cup after the exposure.

The Angle Finder V

N

and Magnifier V

N

can be used with this camera. The Angle Finder makes using

the camera at low angles easier. The Magnifier enlarges the center of the viewfinder image for
critical focusing especially for macro photography. These accessories are mounted on the
viewfinder frame as described above. For more information on these and other accessories, contact
your Konica Minolta dealer.

The optional remote cords (RC-1000S or RC-1000L) can be used to reduce
vibrations from touching the camera during long exposures. Open the
remote-control terminal cover from the right. The cover is attached to the
body to prevent loss; take care not the sever the connector. Insert the plug
of the remote cord into the terminal (1).

The cord can be attached to the camera strap. Open the remote-
cord clip on the strap and push the cord into the grove. Close the
clip until it clicks into place (2).