Руководство Пользователя для Calculated Industries Construction Master Pro
U
SER
’
S
G
UIDE
— 85
(Cont’d)
PREFERENCE
OPTIONS
8) Irregular Jack Rafters
– *OC-OC (On-center spacing maintained
O-C or Mate
on both regular and irregular sides)
– JAC-JAC (regular/irregular Jack rafters
“mate” at the hip/valley, e.g., On-center
spacing not maintained on both sides)
– JAC-JAC (regular/irregular Jack rafters
“mate” at the hip/valley, e.g., On-center
spacing not maintained on both sides)
9) Exponent Off or On
– *Off (Exponential Mode is Off; turns
on Auto-ranging; e.g., if display can’t
show seven digits, will display in next
largest unit).
– On (Exponential Mode is On)
on Auto-ranging; e.g., if display can’t
show seven digits, will display in next
largest unit).
– On (Exponential Mode is On)
10) Meter Linear Display
– *0.000 (linear Meter answers are
always displayed to third decimal place)
– FLOAt (linear Meter answers are
displayed to the maximum number of
decimal places — e.g., 1.234 M + 2.56 M
= 3.794 M)
always displayed to third decimal place)
– FLOAt (linear Meter answers are
displayed to the maximum number of
decimal places — e.g., 1.234 M + 2.56 M
= 3.794 M)
11) Decimal Degree
– *0.00°
Display
– FLOAt
12) Fractional Mode
– *Standard (fractions are displayed to
the nearest fraction)
– Constant (fractions are displayed in
the set fractional resolution)
the nearest fraction)
– Constant (fractions are displayed in
the set fractional resolution)