Руководство Пользователя для Calculated Industries Construction Master Pro
18 — C
ONSTRUCTION
M
ASTER
®
P
RO
/ T
RIG
/ D
ESKTOP
ENTERING DIMENSIONS
Entering Linear Dimensions
When entering Feet-Inch-Fraction values, enter dimensions from
largest to smallest — e.g., Feet before Inches, and Inches before
Fractions. Enter Fractions by entering the numerator (top), pressing
largest to smallest — e.g., Feet before Inches, and Inches before
Fractions. Enter Fractions by entering the numerator (top), pressing
/
(fraction bar key), and then the denominator (bottom).
Note: If a denominator is not entered, the fractional setting value is used.
Examples of Entering Linear Dimensions:
DIMENSION
KEYSTROKES
Clear calculator
o
5 Feet 1-1/2 Inch
5 f 1 i 1 / 2
Clear calculator
o
5 Yards
5 y
Clear calculator
o
17.5 Meters
1 7 • 5 m
Entering Square/Cubic Dimensions
The
Construction Master Pro
lets you easily enter Square and Cubic
values. Simply press a dimensional unit key
two
times to label a
number as a Square value, or
three
times to label a Cubic value.
Note: If you pass the desired dimensional format, keep on pressing the dimensional
unit key until the desired result is displayed again.
unit key until the desired result is displayed again.
Enter Square and Cubic dimensions in the following order:
(1) Enter numerical value (e.g.,
1 0 0
).
(2) Press desired unit key (e.g.,
f
) to label value as “linear”.
KEYSTROKE
DISPLAY
o o
0.
1 0 0 f
100
FEET
(3) Second press of unit key (e.g.,
f f
) labels value as “Square”.
KEYSTROKE
DISPLAY
o o
0.
1 0 0 f f
100
SQ FEET
(4) Third press of unit key (e.g.,
f f f
) labels value as “Cubic”.
KEYSTROKE
DISPLAY
o o
0.
1 0 0 f f f
100
CU FEET
Note: Feet-Inches format cannot be used to enter Square or Cubic values.