Руководство Пользователя для SATO MB410i
Unit 4: Operation and Configuration
Page 4-6
PN 9001190C
MB400i/MB410i Operator Manual
PRINTING VIA THE RS-232C INTERFACE
Use the following procedure to print by connecting to a computer or a handy terminal through an
RS-232C cable option.
RS-232C cable option.
Figure 4-8, Inserting RS-232C Cable
1. Check that all DIP switches are off.
2. Locate the RS-232C interface port cover and lift it up to expose the port.
3. Plug one end of the RS-232C cable firmly into the port. Make sure that the arrow mark on
the connector of the RS- 232C cable matches with the arrow mark by the side of the printer’s
port.
port.
4. Plug the other end of the RS-232C cable into the corresponding RS-232C connector of the
computer or handy terminal. For information on the host device RS-232C connector, refer to
the relevant instruction manual.
the relevant instruction manual.
N
OTE
:
Default RS-232 settings are 19,200 BAUD, no parity, 8 data bits, and one stop bit. To change
them, you must refer to the programming manual, or use the MB400i/MB410i tools utility program
and Windows print driver.
them, you must refer to the programming manual, or use the MB400i/MB410i tools utility program
and Windows print driver.
BASIC SPECIFICATIONS FOR RS-232C INTERFACE
The maximum receive buffer capacity is 128KB. When near full has occurred, 24KB remain.
When near full is released, 52KB remain.
The maximum receive buffer capacity is 128KB. When near full has occurred, 24KB remain.
When near full is released, 52KB remain.
When setting flow control to hardware, the flow control function will be activated by High RS
signal from the occurrence to the release of near full. In this case, buffer overflow can be
avoided.
signal from the occurrence to the release of near full. In this case, buffer overflow can be
avoided.
The printer side connector type is Model number TCS7578-43-201, manufactured by Hosiden
Corporation.
Corporation.
RS-232C cable
RS-232C cover