Справочник Пользователя для Insignia is-hc040917
VIDEO
AM Loop Antenna and FM Indoor Antenna
1.
2.
Uncoil the Antenna wire.
Press down on the Antenna tab to open the terminal.
Connecting the Antenna
The AM and FM antennas connect to the AM and FM termInals
nals on the system's back panel.
They must be hooked up in order to receive clear reception.
HINT
For FM reception, extend antenna to its full
length and arrange the Antenna Higher.
length and arrange the Antenna Higher.
For AM reception, rotate the antenna hori-
zontally to get better reception.
zontally to get better reception.
1.
2.
AM Antenna
wire Connection
wire Connection
Connecting for Power
Make sure you connect all your
other electronic components and
the speakers before plugging your
receiver into the outlet. Plug the
power cord in the wall outlet,
matching the wide blade of the
plug with the wide slot in the outlet. Be sure to insert the plug
completely.
Using Headphones
To listen privately through your audio
system, use the HEADPHONE jack
on the receiver. However,make sure
you turn down the volume before
you put on the headphones. Increase
the volume to the desired level after
headphones are in place.
Notes:
Do not play your headset at a high volume. Hearing experts
advise against continuous extended play.
If you experience a ringing in your ears, reduce volume or
discontinue use.
Always turn down the volume before connecting your headph-
ones.
The speakers are turned off while the headphones plug is
inserted in the HEADPHONE jack.
When you connect a pair of headphones, the listening mode
is set to Stereo, unless it's already set to 2 CH Stereo. When
you disconnect the headphones, the previous listening mode
is resumed.
When the multichannel input is used, only the front left and
right audio can be heard in the headphones.
advise against continuous extended play.
If you experience a ringing in your ears, reduce volume or
discontinue use.
Always turn down the volume before connecting your headph-
ones.
The speakers are turned off while the headphones plug is
inserted in the HEADPHONE jack.
When you connect a pair of headphones, the listening mode
is set to Stereo, unless it's already set to 2 CH Stereo. When
you disconnect the headphones, the previous listening mode
is resumed.
When the multichannel input is used, only the front left and
right audio can be heard in the headphones.
9
Getting Started