Руководство Пользователя для Bunn cdbcf 15

Page 21

Location:
The limit thermostat is located inside the top cover on 
the front side of the tank.

Test Procedures:
1.  Disconnect the brewer from the power source.
2.  Disconnect the wires from the limit thermostat.
3.  With an ohmmeter, check for continuity across 
the limit thermostat terminals.

If continuity is present as described, the limit thermostat 
is operating properly.
If continuity is not present as described, replace the 
limit thermostat.

Removal and Replacement:
1.  Remove the wires from limit thermostat termi-
nals.
2.  Carefully slide the limit thermostat out from under 
the retaining clip and remove limit thermostat.
3.  Carefully slide the new limit thermostat into the 
retaining clip. Ensure the metal face has good contact 
with tank.
 

 

 

Location:
The TCO's are located under the tank at the heater 
connections.

Test Procedures:
1.  Disconnect the brewer from the power source.
2.  Disconnect the TCO from the tank heater.
3.  With an ohmmeter, check for continuity across 
the TCO as shown above.

If continuity is not present as described, replace the 
main harness.

39132 041708