Справочник Пользователя для Epson LX-80

For practice in using SelecType, try setting emphasized mode. First

turn the printer off and back on with the switch on the right side of
the printer. Then press the ON LINE and FF buttons at the same

time. The LX-80 beeps to tell you that it is in SelecType mode, the
READY light turns off, and the ON LINE light begins blinking.
Then press the ON LINE button two times to select emphasized.

(The printer beeps each time you press the ON LINE button in

SelecType mode.) After that, press the FF button once to set the
function.

You have now set emphasized mode. Next, press the LF button

once, and your panel buttons return to their normal operation, but
your printer is in emphasized mode. Since this is only an exercise,

turn the 

LX-80 off and back on again to cancel all settings and prepare

for the next exercise.

You will probably use SelecType with commercial software as well

as with BASIC or another programming language, but for now try a
simple exercise using BASIC. You don’t need to know anything

about programming for this exercise. It is merely for practice. If your
computer system does not include BASIC or if you would rather not
use it, skip to the next section.

Type the short BASIC program listed below:

 

 

     

 

 

 

 

 

   

 

 

   

 

 

Next, print a listing of the program using LLIST or your computer

system’s print listing command. Your LX-SO prints your program in

ordinary single-strike pica, as illustrated below in our sample
program.

 

         

 

     

   

         

             

 

           

         

   , 

         

 

   

 

 

     

         

     

 , ,     

   

           

Now that you have a sample program to list, follow these simple

steps to print your listing in compressed mode:

1) See that both the ON LINE light and the READY light are on.

2) Press the ON LINE and FF buttons at the same time. You hear a

beep to signal that SelecType is on.

18