Инструкции Пользователя для Standard Horizon CP1000C
Page 12
FF520
The FF520 is not connected with the GPS Chart plotter.
· 1 SHORT FLASH EVERY 2 SECONDS
The FF520 is connected to the GPS Chart plotter and is operating correctly.
· 2 SHORT FLASHES EVERY 2 SECONDS
The FF520 is not operating as it is waiting for a command from the GPS chart plotter.
· 3 SHORT FLASHES EVERY 2 SECOND
A non-Standard Horizon transducer (without transducer ID) has been connected
· 4 SHORT FLASHES EVERY 2 SECONDS
No transducer connected.
2.4
POWER CONNECTIONS
It is recommended the installation of a switch and a 5A fuse (not supplied) in the positive
DC supply to the FF520. The FF520 is designed to remain in stand-by even when the power
of the GPS chartplotter is turned off, this is the need for a switch so the vessels battery will
not be drained..
In the example below you will notice the positive DC power connection is run through a
switch and a fuse before connecting it to the FF520 and the GPS chartplotters.
DC supply to the FF520. The FF520 is designed to remain in stand-by even when the power
of the GPS chartplotter is turned off, this is the need for a switch so the vessels battery will
not be drained..
In the example below you will notice the positive DC power connection is run through a
switch and a fuse before connecting it to the FF520 and the GPS chartplotters.
Figure 2.4 - The FF520 Power Connection
2.5
GPS CHARTPLOTTERS SOFTWARE UPDATE
Inside the box containing the FF520 you will find 3 software upgrade CARDs. These CARDs
are used to update the software in the GPS chartplotters to be compatible with the FF520
and will load the MAX cartography operating system from C-Map. Please note that NT
are used to update the software in the GPS chartplotters to be compatible with the FF520
and will load the MAX cartography operating system from C-Map. Please note that NT
+
cartography cards still can be used, but to use all the MAX features a MAX cartography card
will have to be purchased.
will have to be purchased.