Справочник Пользователя для APC MGE Galaxy 3500 G35TSBPAR10K15F
Модели
G35TSBPAR10K15F
990-3601A-001
7/2010
*990-3601A-
Installation
MGE™ Galaxy™ 3500 and Smart-UPS
®
VT
Parallel Maintenance Bypass Panel
Floor Mount
45 kVA and 90 kVA 208 V
IMPORTANT SAFETY INSTRUCTIONS
- SAVE THESE INSTRUCTIONS
Warning: ALL safety instructions in the Safety Sheet
(990-2940) must be read, understood and followed when
installing the UPS system. Failure to do so could result in
equipment damage, serious injury, or death.
(990-2940) must be read, understood and followed when
installing the UPS system. Failure to do so could result in
equipment damage, serious injury, or death.
Caution: All electrical power and power control wiring
must be installed by a qualified electrician, and must comply
with local and national regulations for maximum power
rating.
must be installed by a qualified electrician, and must comply
with local and national regulations for maximum power
rating.
Caution: Operation and Maintenance must only be
performed by qualified personnel.
performed by qualified personnel.
Product Overview
45 kVA
90 kVA
Site Planning
Note: Refer to the UPS Receiving and Unpacking sheet
(990-2940 for MGE Galaxy 3500 and 990-1747 for Smart-
UPS VT) to determine the space requirements for the MBP.
Consult local codes for any additional requirements. Ideally,
install the MBP in a location close to the UPS.
(990-2940 for MGE Galaxy 3500 and 990-1747 for Smart-
UPS VT) to determine the space requirements for the MBP.
Consult local codes for any additional requirements. Ideally,
install the MBP in a location close to the UPS.
Smart-UPS
®
VT
45 kVA and 90 kVA
MGE™ Galaxy™ 3500
45 kVA and 90 kVA
Q2 UPS isolations
Input neutral busbar
Q3 Maintenance bypass. A
Phillips screwdriver is required
to unlock Q3
Phillips screwdriver is required
to unlock Q3
PE/ground busbar
Q4 system isolation
Mains input
MBP CAN I/O boards (x3)
Critical load
Control fuse
UPS output
Led indicators
Output neutral busbar
Rear view
Front view
PE/G
N
Q2 UPS isolations
Input
neutral busbar
Q3 Maintenance bypass. A
Phillips screwdriver is required
to unlock Q3
Phillips screwdriver is required
to unlock Q3
PE/ground busbar
Q4 system isolation
Mains input
MBP can I/O boards (x3)
Critical load
Control fuse
UPS output
Led indicators
Output neutral busbar
Rear view
Front view
PE/G
N