Инструкция для Sony ILCE-3000





The model and serial numbers are located on the bottom. Record the serial number in the 

space provided below. Refer to these numbers whenever you call your Sony dealer regarding 

this product.

Model No.   ILCE-3000
Serial No.   ______________________________
Model No.   AC-UB10C/AC-UB10D
Serial No.   ______________________________

If the shape of the plug does not fit the power outlet, use an attachment plug adaptor of the 

proper configuration for the power outlet.

  Checking the supplied item

  AC adaptor AC-UB10C/UB10D (1) 

  Charging the battery pack

Set the power switch to OFF.
Open the cover by sliding the lever.
Insert the battery pack completely, using the tip of the battery 
to press the lock lever (A).
Close the cover.
Connect the camera to the AC Adaptor (supplied) using the 
micro USB cable (B) (supplied). Connect the AC Adaptor to the 
wall outlet (wall socket) (C).

When charging is finished, disconnect the AC Adaptor from the wall outlet (wall socket).

Be sure to use only genuine Sony brand battery packs, micro USB cable (supplied) and 

AC Adaptor (supplied).

 

The charging time is approximately 290 min. using the AC Adaptor (supplied).

The above charging time applies when charging a fully depleted battery pack (supplied) 

at a temperature of 25°C (77°F). Charging time may take longer depending on conditions 

of use and circumstances.



 Using your camera abroad – Power source

You can use your camera and AC Adaptor in any countries/regions where the power supply 

is within 100 V to 240 V AC, 50 Hz/60 Hz.

An electronic voltage transformer is unnecessary and its use may cause a malfunction.

The charge lamp on the camera flashes when charging the battery pack.

The charge lamp flashes in two ways, fast (about 0.3-second intervals) or slow (about  

1.3-second intervals). If the charge lamp is flashing fast, remove the battery pack and 

reattach the same battery pack securely, or disconnect and reconnect the USB cable. If 

the charge lamp flashes fast again, it suggests that there is something wrong with the 

battery pack, AC Adaptor (supplied), or USB cable. Slow flashing indicates that charging 

is suspended because the ambient temperature is outside the suitable range for charging 

the battery pack. Charging will resume and the charge lamp will be lit when the ambient 

temperature returns to within the suitable temperature. The optimal temperature for 

charging the battery pack is between 10 °C and 30 °C (50 °F and 86 °F).

Power requirements: AC 100 V to 240 V, 50 Hz/60 Hz, 70 mA

Output voltage: DC 5 V, 0.5 A

Operating temperature: 0 °C to 40 °C (32 °F to 104 °F)

Storage temperature: –20 °C to +60 °C (–4 °F to +140 °F)

Dimensions: Approx. 50 mm × 22 mm × 54 mm (2 inches × 7/8 inches × 2 1/4 inches) 

(W/H/D)

Mass (Approx.): 48 g (1.7 oz)












2013 Sony Corporation    Printed in Thailand

4-477-464-11(1)