Инструкция для Sony CDX-G3150UP

Скачать
Страница из 44
2
GB
The nameplate indicating operating voltage, etc., is 
located on the bottom of the chassis.
Warning
This equipment has been tested and found to 
comply with the limits for a Class B digital device, 
pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable 
protection against harmful interference in a 
residential installation. This equipment generates, 
uses, and can radiate radio frequency energy and, if 
not installed and used in accordance with the 
instructions, may cause harmful interference to 
radio communications.
However, there is no guarantee that interference 
will not occur in a particular installation. If this 
equipment does cause harmful interference to 
radio or television reception, which can be 
determined by turning the equipment off and on, 
the user is encouraged to try to correct the 
interference by one or more of the following 
measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment 
and receiver.
 Connect the equipment into an outlet on a circuit 
different from that to which the receiver is 
connected.
 Consult the dealer or an experienced radio/TV 
technician for help.
You are cautioned that any changes or 
modifications not expressly approved in this 
manual could void your authority to operate this 
equipment.
CAUTION
The use of optical instruments with this product will 
increase eye hazard.
For the State of California, USA only
Perchlorate Material – special handling may apply, 
See
www.dtsc.ca.gov/hazardouswaste/perchlorate
Note on the lithium battery
Do not expose the battery to excessive heat such as 
direct sunlight, fire or the like.
Disclaimer regarding services offered by 
third parties
Services offered by third parties may be changed, 
suspended, or terminated without prior notice. 
Sony does not bear any responsibility in these sorts 
of situations.
For safety, be sure to install this unit in the 
dashboard of the car as the rear side of the unit 
becomes hot during use.
For details, see “Connection/Installation” 
(page 17).
Warning if your car’s ignition has no ACC 
position
Be sure to set the AUTO OFF function (page 10). 
The unit will shut off completely and 
automatically in the set time after the unit is 
turned off, which prevents battery drain. If you 
do not set the AUTO OFF function, press and hold 
OFF until the display disappears each time you 
turn the ignition off.