Руководство По Установке для KitchenAid 30-Inch 5-Burner Dual Fuel Convection Slide-In Range with Baking Drawer

4. When the range is at the correct height, check that there is 

adequate clearance under the range for the anti-tip bracket. 
Before sliding range into its final location, check that the anti-
tip bracket will slide under the range and onto the rear 
leveling leg prior to anti-tip bracket installation.

NOTE: If a Trim Kit will be used, the top of the cooktop 
should be higher than the counter. See the Installation 
Instructions included with the Trim Kit for the correct height.

1. Place level on the oven bottom, as indicated in one of the two 

figures below, depending on the size of the level. Check with 
the level side to side and front to back.

2. If range is not level, use a wrench or pliers to adjust leveling 

legs up or down until the range is level.

NOTE: Range must be level for satisfactory baking 
performance and best cleaning results using AquaLift

®

 

Self-Clean Technology.

If your home has a 3- or 4-wire receptacle, continue with “Install 
Using a Power Supply Cord.” If your home has a 3- or 4-wire 
direct connection, go to “Install Using Direct Wire.”

1. Disconnect power.

2. Remove the lower access cover screws located on the back 

of the range. Pull the bottom of the cover toward you and out 
to remove cover from range. 

A

B

C