Руководство По Установке для KitchenAid 30-Inch 5-Burner Dual Fuel Convection Slide-In Range with Baking Drawer

4. Align the gas tube opening in the burner base with the orifice 

holder on the cooktop and the igniter electrode with the notch 
in the burner base.

5. Place the burner caps on the appropriate burner bases.

IMPORTANT: The bottom of the small and medium caps are 
different. Do not put the wrong size burner cap on the burner 
base.

Burner caps should be level when properly positioned. If 
burner caps are not properly positioned, surface burners will 
not light. The burner cap should not rock or wobble when 
properly aligned.

6. Place burner grates over burners and caps.

7. Plug into appropriate outlet. See the appropriate “Electrical 

Requirements” section.

8. Turn on power.

1. Slide range into final location, making sure rear leveling leg 

slides into anti-tip bracket.

2. Remove the premium storage drawer. See the “Remove/

Replace Drawer” section.

3. Use a flashlight to look underneath the bottom of the range.

4. Visually check that the rear range foot is inserted into the slot 

of the anti-tip bracket.

1. Slide range into final location, making sure rear leveling leg 

slides into anti-tip bracket. Leave a 1" (2.5 cm) gap between 
the back of the range and the back wall.

2. Place the outside of your foot against the bottom front of the 

warming drawer or baking drawer to keep the range from 
moving, and then grasp the back of the range, as shown.

3. Slowly attempt to tilt the range forward. 

If you encounter immediate resistance, the range foot is 
engaged in the anti-tip bracket. Go to Step 8.

4. If the rear of the range lifts more than ½" (1.3 cm) off the floor 

without resistance, stop tilting the range and lower it gently 
back to the floor. The range foot is not engaged in the anti-tip 
bracket.

IMPORTANT: If there is a snapping or popping sound when 
lifting the range, the range may not be fully engaged in the 
bracket. Check to see if there are obstructions keeping the 
range from sliding to the wall or keeping the range foot from 
sliding into the bracket. Verify that the bracket is held 
securely in place by the mounting screws.

5. Slide the range forward, and verify that the anti-tip bracket is 

securely attached to the floor or wall.

6. Slide range back so the rear range foot is inserted into the 

slot of the anti-tip bracket.

A

B

C

D

E

A

B