Руководство По Установке для Netgear GS510TP – ProSAFE 8-Port Gigabit Smart Switch with PoE and 2 fiber SFP ports

This symbol was placed in accordance with the European Union Directive 2002/96 on the Waste 

Electrical and Electronic Equipment (the WEEE Directive). If disposed of within the European Union, 

this product should be treated and recycled in accordance with the laws of your jurisdiction 

implementing the WEEE Directive.

©2011 by NETGEAR, Inc. All rights reserved. NETGEAR and the NETGEAR logo are registered trademarks of 

NETGEAR, Inc. in the United States and/or other countries. Other brand and product names are trademarks or 

registered trademarks of their respective holders. Information is subject to change without notice. 

Make sure the switch has completed its boot cycle and is operational before you 
click Discover.
The Smart Control Center utility finds the switch and displays information such 
as its MAC Address, IP Address, and model number. 

      

           

If you cannot view your switch, verify that the cable connections are secure and 
that the IP address configuration of the administrative computer is in the same 
subnet as the switch. Then click the Discover button.

Click to select the line displaying the details of your switch. If there are multiple 

Smart Switches in your network, then be sure to select the switch you want to 

configure.

Click Web Browser Access to launch a Web browser on the administrative 

computer and view the switch log in screen. The Login dialog appears.

 

Enter the default password of password in lowercase letters and click Login. 
The System Information page appears.

             

Configure the switch for your network. 
For information about switch features and for assistance with configuration 
procedures, consult the online Software Administration Manual. 
For information about each field to view or configure, click the help icon 

 

available on each page of the switch user interface.

After you power up the GS510TP switch, wait at least two minutes before you 
click the Discover button on the Smart Control Center utility.

For each powered-on device connected to the Smart Switch with a securely 
plugged in Ethernet cable, the corresponding port status LED will light. 

Make sure the administrative computer’s network settings are correct. 

In most cases, computers are configured to obtain an IP address automatically 
via DHCP. If your network uses static IP addresses, be sure the switch and 
computer are configured with valid IP addresses that are in the same subnet.

Thank you for selecting NETGEAR products.

After installing your device, locate the serial number on the label of your product and 
use it to register your product at 

Registration is 

required before you can use the telephone support service. Registration via our 
website is strongly recommended.

Go to 

for product updates and web support

For additional information about setting up, configuring, and using your switch, see 
the Software Administration Manual

For complete DoC, please visit the NETGEAR EU Declarations of Conformity 
website at: 

.

GS510TP IG 19Sept11.fm  Page 2  Monday, September 19, 2011  1:50 PM