Справочник Пользователя для Sony alpha dslr-a500
Pr
ep
ar
ar
ing the
ca
mer
mer
a
33
If dust or debris enters the camera and lands on the image sensor (the part
that acts as the film), it may appear on the photo image, depending on the
shooting environment. If there is dust on the image sensor, use a
commercially available blower and clean the image sensor following the
steps below. You can easily clean the image sensor using only the blower
and the anti-dust function.
that acts as the film), it may appear on the photo image, depending on the
shooting environment. If there is dust on the image sensor, use a
commercially available blower and clean the image sensor following the
steps below. You can easily clean the image sensor using only the blower
and the anti-dust function.
Notes
• Cleaning can be performed only when the battery level is
• Cleaning can be performed only when the battery level is
(three remaining
battery icons) or more. Low battery power during cleaning can cause damage to the
shutter. The cleaning should be completed quickly. The use of an AC-PW10AM AC
Adaptor (sold separately) is recommended.
shutter. The cleaning should be completed quickly. The use of an AC-PW10AM AC
Adaptor (sold separately) is recommended.
• Do not use a spray blower because it may scatter water droplets inside the camera
body.
Cleaning the image sensor
1
Confirm that the battery is fully charged (page 18).
2
Press the MENU button, then
select
select
3
with
b
/B on the
controller.
MENU button
3
Select [Cleaning mode] with v/V,
then press the center of the
controller.
then press the center of the
controller.
The message “After cleaning, turn
camera off. Continue?” appears.
camera off. Continue?” appears.
4
Select [OK] with v, and press the center of the controller.
After the image sensor vibrates for a short time, the mirror in front is lifted.
5
Detach the lens (page 21).